Archer C5 V4 (AC1200 dual-band Wi-Fi Gigabit Router) - Discussion | [WiFirouter]: 300MB \ S - 867MB \ s + 4x1gb | X1 USB 2.0 (3G or 4G Modem)



Rep: (161)
Archer C5 V4 (AC1200 dual-band Wi-Fi Gigabit Router) - discussion
Wifirouter: 2.4GHz (300Mbit \ s) - 5GHz (867Mbit \ s) + 4 • 1Gbit \ s | USB: X1 USB 2.0 (3G or 4G Modem)

Attached Image

The forum decided to post images under the spoiler

Description
Super-speed dual-band Wi-Fi to 1.2 Gbps: 300 Mbps by 2.4 GHz and 867 Mbps by 5 GHz
Agile Config support - allows telecom operators to independently produce basic customization
Simple remote control, the TR-069 protocol allows the operator to remotely manage and configure end-user devices
4 External antennas for maximum omnidirectional wireless network coverage
USB 2.0 port allows you to share files and media with any network devices.
Connecting 3G / 4G modems to the USB port (check the list of compatible 3G / 4G USB modems)
Support 1 WAN Gigabit Port and 4 Gigabit LAN ports for ultrafast data transmission
IGMP Proxy support, Most mode and 802.1Q TAG VLAN for IPTV service
Additional Images
Attached Image
Attached Image
Attached Image
Specifications
HARDWARE CHARACTERISTICS
Interface 4 LAN ports 10/100/1000 Mbit / s
1 10/100/1000 Mbps WAN port
1 USB 2.0 port
Power supply 12 in post. Current / 1 A
Sizes (SHHDHV) 230 x 144 x 37 mm
Antenna Type 4 Fixed Antennas
Fastening hole for wall mount

PARAMETERS OF WIRELESS MODULE
IEEE 802.11n / G / B 2,4 GHz wireless network standards
IEEE 802.11ac / n / a 5 GHz
Frequency range (reception and transmission) 2.4 GHz and 5 GHz
2.4 GHz transmission freaks: up to 300 Mbps
5 GHz: up to 867 Mbps
Sensitivity (reception) 5 GHz:
11A 54 Mbps: -73 dBm
11AC VHT20 MCS8: -66 dBm
11AC VHT40 MCS9: -61 dBm
11AC VHT80 MCS9: -58 dBm
2.4 GHz:
11G 54 Mbps: -75 dBm;
11n HT20 MCS7: -73 dBm;
11N HT40 MCS7: -70 dBm
EIRP (Wireless Power)<20 dBm or<100 mW
Wireless functions Enable / disable wireless broadcast, WDS bridge, WMM, wireless connection statistics
Wireless Network Protection Authentication WPA / WPA2 and WPA-PSK / WPA2-PSK and TKIP / AES Encryption
64/128-bit encryption WEP and ACL (Access Control Lists) Wireless LAN

CHARACTERISTICS OF SOFTWARE
QoS (prioritization of data) WMM, Bandwidth Control
WAN Connection Type Dynamic IP / Static IP / PPPOE / PPTP / L2TP
Control Access Control, Local Control, Remote Control
DHCP server, client, list of DHCP clients,
address reservation
Port Forwarding Virtual Server, Port Triggering, UPnP, DMZ
Dynamic DNS Dyndns, NO-IP
Access control WMM, bandwidth control
Parental control, local control control, node list, schedule access, rules management
Supported protocols IPv4 and IPv6
IGMP Support IGMP Proxy, Most mode and 802.1Q TAG VLAN for IPTV service

OTHER
Delivery set AC1200 dual-band Wi-Fi Gigabit Router
Power adapter
Quick Setup Guide
Cable RJ45
Microsoft Windows 10 / 8.1 / 8/7 / Vista / XP / 2000/8 / 78SE, Mac OS, NetWare, Unix or Linux
Environmental Parameters Operating Temperature: 0 в„ѓ - 40
Storage temperature: -40 в„ѓ - 70 в„ѓ
Relative air humidity during operation: 10% - 90%, without condensation
Relative humidity during storage: 5% - 90%, without condensation
CE, FCC, RoHS certification
Firmware
Useful


Post has been editedM | A | G - 18.12.20, 15:55
Reason for editing: Instructions for the firmware of the router via TFTP



Rep: (11)
Mr.Yamakasi @ 12.04.20, 03:24*
There is a poppy just yours. It changes the poppy at the beginning or at the end of some devices, and some gives his own. Just poppy there is not the one that in the smartphone, for example, is specified or from the network. he in the repeater mode changes a little

Well, I say "left")))) Of course the substitution of the MAC address in some cases, especially criminal, good, but not my case))
Mr.Yamakasi @ 12.04.20, 03:24*
If the wi fi is distributed to duplicate, but purely on the wire

Maybe we have a different understanding in the duplication of WiFi, but in the option as it is now, it works well and suits (however, it worked on other devices connected via WDS): The bridge rises from the main router on WiFi, and in turn the receiving party may Also hand out WiFi, SSID can specify your own, you can generally, it is more convenient for me to be different SSID so that it is easier to understand what is connected now, well, well, or special connect to the second SSID.

Post has been editediamfriend79 - 12.04.20, 14:55



Rep: (34)
IAMFRIEND79 @ 12.04.20, 12:07*
can we have a different understanding in duplication WiFi

IAMFRIEND79 @ 12.04.20, 12:07*
SSID can specify its own, you can generally, it is more convenient for me to different SSID

Well, then there will be 2 networks displayed with the same name! And when reconnecting from one router to another, there will be a break for a few seconds. Because It will be reconnected in fact in a friend network! And yes, and the password must necessarily have the same to have)
The repeater works otherwise. That's the whole difference. Yes, as convenient. So you need to do. that's all.

Post has been editedmr.Yamakasi - 12.04.20, 22:41



Rep: (11)
Mr.Yamakasi @ 13.04.20, 00:40*
The repeater works otherwise. That's the whole difference.

It may be, but in the repeater mode, it was possible to set the name of the network, did not study in the details, but I tried different SSIDs and the same. It may be switched smoothly, I did not try, but when I was with another IP due to the change of the address, when connected, it would seem, to the desired SSID (both SSIDs were the same), there were several minutes of misunderstanding, what happens))



Rep: (0)
I do something wrong! I can not comply with 128k
Attached Image



Rep: (1)
The forum, faced a problem for the official. The last firmware (was originally with it), which periodically throws the connected devices, which, of course, it is annoying. I decided to flash (sewed phones, router, but which with a sim card through an elf). It turned out that the TFTP server is needed. So, I do according to the instructions, I tried 3 programs for TFTP, but it does not work. Is it possible to throw firmware via the web interface or oxic? Thank you



Rep: (83)
Kvadrat733 @ 18.04.20, 16:40*
I am doing something wrong

I think that you are very original formulating the question in the form of a graphic rebus. In this case, you will have to wait for a telepath lover to solve them. It is better to reformulate more traditionally if you are really interested in the answer.

* Pieroff, Instructions for sure workers. Once again, accurately check the settings, IP addresses. And do not forget to turn off all sorts of firewalls and antiviruses.



Rep: (3)
* Pieroff,

I flashing the TFTPD64 software according to the instructions, having previously changed the settings (as on the screen)
Attached Image
. Try - everything will turn out: yes2:



Rep: (0)
I can't find 128K to recar



Rep: (83)
* Kvadrat733,
And why add 128k to recovery? Usually, the 128K empty file is added to the start of the firmware file to get a new recovery file and this new file is used to install through the recovery mode.



Rep: (0)
To go from the drain. Unpack the folder with TFTP.
Attached filetp_recovery.zip (7.37 MB)

Name: TP_RECOVERY.BIN.
Size: 7929860 bytes (7744 KIB)
CRC32: 23195BF8.
CRC64: 2A80CCBBB6A3C507B.
SHA256: 2FB5FEBF01C5F92103113AC990E09B85FF7456DB0909F069F87BA0741FFE36C0.
SHA1: 3345AAC1EA2BFA2A23114E2356EF6ABD7EB5EE1C.
Blake2sp: FDC65D0A41DC59FCED86125A8D820EC07AFD8032045AA4706A507103B24DE9BB.


To this recvari need 128k Doby?



Rep: (83)
* Kvadrat733, I do not know where you took this file and do not want to play guess.
I can only assume that the author of the file has already done everything forKrivorukovSound users who do not need to read and execute instructions.



Rep: (0)
Krivorukov: rofl:! There is a little! Speaking for the hint!
P / S Router flashed but I can now go to it by 192,168,0,1



Rep: (83)
* Kvadrat733, Instead of 192,168,0,1 need 192.168. 1 .1



Rep: (25)
Hello to all.
Has anyone used an automatic reboot on stock firmware? The essence is that I use, and when installing the last of. The firmware router is not rebooted by a machine. I found the reason, he, after some time of work, less than the interval of reboot, can not get the time from the Internet and ... Everything ... Who knows how is it treated?
Previously addressed support, confirmed that the reboot did not work precisely if it was impossible to get the time. Switching a bunch of firmware with them. He helped only the bet, made, in essence, under me). Long lived on it. But then I got to the site I saw that from that time there were already 2 updates, and I decided to update it too much. It simply did not work out, requested the transition firmware, well, and updated. Result, no reboot. I tried to return to the beta, it does not immediately sew, the transition now also does not accept the router. As a result, HZ, what to do ... discharges, naturally, during the firmware did.
Experts help)



Rep: (3)
On the firmware, you need a constantly USB flash drive to install packages from ENTWARE?



Rep: (594)
* scratch2010 Yes, OPT you unfold on it.



Rep: (11)
Guys, the old router ordered a long time to live, the provider recommends this model.
Actually, the question is, for the purposes turned on and forgotten, nothing is needed from it, except for uninterrupted work and support speed at least 50-70 MB., Will suit?



Rep: (25)
* tomiloff80,
Without a regular reboot on the stock firmware begins to pour up approximately after a week. Therefore, I am fighting with a reboot. Here on the batte, I worked stable, the hell pulled to update



Rep: (13)
Tomiloff80 @ 25.04.20, 10:36*
50-70 MB


Already there are models newer and more successful. But, in principle, you can take. There are no C5 stores. They are positioned as providers. If the provider is selling so far, you can take. But I would choose something else. Something from asus or kinetics.

Posted on 25.04.2020, 11:00:

* _valentin_,
You can configure the reboot once every 3 days by automatt, at night, for example.



Rep: (11)
* kart120 , sells, but I found on Avito, I see no reason to overpay. 3800 against 1,500 Avito.

Posted on 25.04.2020, 11:06:

_Valentin_ @ 25.04.20, 12:56*
Point in a week
I am surprised, it would seem that I would acquire a finished product with certain properties, they do not work, and it's kind of ok?)
The old Dir300 stood for me for more than 10 years, I did not fit to him, everything suited.


Full version    

Help     rules

Now: 03.01.21, 03:55