Intertelecom number firmware in Haier CE81b modem
1. Install the driver from the removable disk of the modem or by
link (google drive)After the driver is successfully installed, 4 ports will be installed in the device manager.
2. Run DFS, click on the Ports button and connect to the port
EVDO Rev B Diagnostics(double click LMB)
3. Press the SPC button (default 000000)
4. In the NAM tab:
- read the data, click the Read buttons
- enter the value in the IMSI field: 510090123456789 (instead 0123456789 - received subscriber number)
- upload the PRL file
- press both buttons Write
5. In the DATA tab:
- read with the Read button
- set Rev B mode
- register username and password (IT or 3G_TURBO), your number and chap-ss
- write changes with the Write button
6. In the MOBILE IP tab:
- click Read
- choose Simple IP
- click Write
- press reset
After the reboot, the modem will see the Intertelecom network and you can now activate the number - create a connection, go online, select a tariff, recharge the number and use the Internet access.
Important note! The Haier CE81b modem is locked under the Smartfren network, so instead of 25504, you need to register 51009 in the IMSI field or untie it from the operator (using the AT command, see below under the spoiler).
Useful AT commands (sent to the modem port): unlock modem diagnostic port
operator decoupling:
AT + BMLCKCSNID = 0.0.0-65535.0-65535
disabling the built-in CD-ROM:
inclusion of the built-in CD-ROM: