Archer C7 - Discussion | Wi-Fi Router

Rep: (3)
TP-Link Archer C7 (AC1750 Dual Band Wi-Fi Gigabit Router)- Discussion
Wi-Fi Router 802.11a / b / g / n / ac | 2.4GHz frequency (450Mbit \ s) | 5GHz frequency (1300Mbit \ s) | LAN 4x1000Mbit \ s | USB 2x2.0 type A |

Attached Image

The forum decided to post images under the spoilerPicture

Interface 4 LAN ports 10/100/1000 Mbit / s
1 10/100/1000 Mbps WAN port
2 USB 2.0 ports
Buttons WPS / Reset Button
Wireless on / off button (wireless on / off)
Power On / Off Button
External power supply 12 V DC / 2.5 A
Dimensions (WxLxH) 243 x 160.6 x 32.5 mm
Antenna type 3 removable 5 GHz antennas with 5 dBi gain (RP-SMA)
3 internal 2.4 GHz antennas

IEEE 802.11ac / n / a wireless standards for 5 GHz frequency
IEEE 802.11b / g / n for the 2.4 GHz frequency
Frequency range (receive and transmit) 2400-2483.5 MHz
5150-5350 MHz
5 GHz transmission speed: up to 1300 Mbps
2.4 GHz: up to 450 Mbps
Sensitivity (reception) 5 GHz пјљ
11a 6 Mbps -96 dBm
11a 54 Mbps: -79 dBm
11ac HT20: -71 dBm
11ac HT40: -66 dBm
11ac HT80: -63 dBm
2.4 GHz
11g 54M: -77 dBm
11n HT20: -74 dBm
11n HT40: -72 dBm
EIRP (Wireless Power)<20 dBm or<100 mW
Wireless functions Enable / disable wireless broadcast, WDS bridge, WMM, wireless connection statistics
Wireless Security Encryption Modes: 64/128-bit WEP, WPA / WPA2, WPA-PSK / WPA2-PSK

QoS (data prioritization) WMM, bandwidth control
WAN connection type Dynamic IP / Static IP / PPPoE /
PPTP (Dual Access) / L2TP (Dual Access) / BigPond
Management Access Control
Local management
Remote control
DHCP server, client, list of DHCP clients,
address reservation
Port Forwarding Virtual Server, Port Triggering, UPnP, DMZ
Dynamic DNS DynDns, Comexe, NO-IP
VPN traffic pass PPTP, L2TP, IPSec
Access Control Parental Control, Local Management Control, Node List, Scheduled Access, Rules Management
Network security (firewall) Protection against DoS attacks, SPI firewall, filtering by IP address / MAC address, domain name, binding by IP and MAC address
Protocols Supports IPv4 and IPv6
Shared via USB Support Samba (storage device) / FTP server / media server / print server
2.4 GHz guest network guest network
one 5 GHz guest network

CE, FCC, RoHS certification
Package Archer C7
3 removable antennas
Power adapter
Ethernet cable
Quick Setup Guide
System Requirements Microsoft Windows 98SE, NT, 2000, XP, Vista в„ў or Windows 7, Windows 8 / 8.1 / 10
MAC OS, NetWare, UNIX or Linux
Environmental Parameters Operating Temperature: 0 в„ѓ - 40
Storage temperature: -40 в„ѓ - 70 в„ѓ
Operating Humidity: 10% - 90%, without condensation
Humidity during storage: 5% - 90%, without condensation

Post has been editedninja88 - 29.10.20, 19:23
Reason for editing: Dump Archer c7 v5

Rep: (577)
The curator of the topic is appointedA.r.c.h.e.r.

Rep: (412)
makcim.999999 @ 06/27/18, 23:06*
Wait 10-15 minutes, then try to connect to it

Hmm ... you can try. 5 minutes I was accurate. During these 5 minutes, WiFi from the router never appeared. I will try in the weekend

Rep: (2)
DD-wrt and Openwrt only without 5Ghz cards work on the V1 - if you remove it (replaced by supported) - zavedet.

Rep: (412)
* it1999,
I understood, thanks, I will try first. If not for being done, I will try to restore via TFTP

Rep: (412)
MDS3D @ 07/01/18, 02:12*
Is it depends on the firmware or from settings?

I think from version. I have V1, and there has never been such an opportunity

Rep: (58)
* mds3d,
What is your firmware on the router?

Rep: (412)
makcim.999999 @ 06/27/18, 23:06*
turn on the router and wait 10-15 minutes,

It did not help, probably because
IT1999 @ 06/30/18, 12:50*
DD-WRT and OpenWRT on V1 work only without 5GHz fees

But I did not disassemble, since there it is necessary to tear the sticker, and I am thinking to sell it.
MDS3D @ 07/01/18, 17:17*
I have version v2

Most likely, she also has no hardware support
MDS3D @ 07/01/18, 17:17*
Tighten the instructions for connections in the bridge and repeater connection to the topic header, so that people do not have experience do not occur on old rake.

Yes, if there is an opportunity, then no instruction is needed, it will simply be the "Router Mode" button, where the repeater mode will be cliking where the list of visible networks will open, select the desired, enter the password and everything!
MDS3D @ 07/01/18, 17:17*
It seems to be set up WDS, but there was never internet from another router

Capricious thing. And I don't even have.
A.R.C.H.E.R. @ 06/27/18, 14:39*
After TFTP, unsubscribe: my instruction helped or not.

Unfortunately no, and probably because* it1999 .
Firmware (Archer-C7-V1-Squashfs-Factory.bin), which can be downloaded on the link in your instruction may even have been firmage, but there was no result, that is, the router started, I had a network in network connections, but I immediately appeared , and judging by the lights on the router, it is clear that it is overloaded.
But I helped a stripped version of the firmware TP-Link from Friedzombie, a link to which I shared* butaford , for which he, too, thank you so much.

Rep: (6)
* paxan281281 I have v2. Started it, I did not understand kak.Vklyuchal at night, then it was connected

Rep: (412)
Makcim.999999 @ 07/01/18, 20:25*
I got it, I did not understand how. It turned out on the night, then he connected

Well, as I said WDS - a capricious thing

Rep: (58)
* mds3d,
Try to flash DD-VD and set up in it.

Rep: (58)
* paxan281281
It's good that everything happened. For V.1, my method is not suitable. SPS for disciplice.

Posted on 01.07.2018, 21:57:

MDS3D @ 07/01/18, 21:56*
I understand that if I have a second version of the second version of V2, then you need to upload a DD-WRT for v2 /

I really understand everything. Better put a newer versionfrom here

Post has been editedfaceless - 01.07.18, 22:00

Rep: (58)
MDS3D @ 07/01/18, 22:02*
You just need to specify the path to the zip archive, right?

No, you need to unpack and flash .bin

Posted on 01.07.2018, 22:06:

MDS3D @ 07/01/18, 22:02*
Link to the page does not open

Strange, everything opens.

Rep: (58)
MDS3D @ 07/01/18, 22:21*
You can throw the plz file.

In the cap- useful added mirror

Post has been editedfaceless - 01.07.18, 22:32

Rep: (448)
MDS3D @ 07/01/18, 22:21*
But the functions "repeater" never appeared ...

It is worth smoking Google to understand what kind of mode.
TP-LINK TL-WR842ND - Discussion

Rep: (448)
MDS3D @ 07/01/18, 22:40*
We must take depending on the router as well as from the region ....,

Router +. router versions (region on drum :-d)

Post has been editedHerzz - 01.07.18, 22:46

Rep: (58)
MDS3D @ 07/01/18, 22:40*
What should be specifically downloaded? poke the nose plz
Swing from there 2 files:
For firmware DD-VRT from the flow to flashonlyFactory-to-DDWRT.BIN file

Rep: (58)
* mds3d,

Attached files

Attached fileC7V.2.RAR(27.65 MB)

Rep: (448)
MDS3D @ 07/01/18, 22:57*
direct link

Attached files

Attached MB)
Attached MB)

Post has been editedHerzz - 01.07.18, 23:06

Rep: (58)
MDS3D @ 07/01/18, 23:15*
And the second file for what is needed?

To update from DD-VD, while you don't need it

Rep: (448)
* mds3d,
What would you doon the drain could return(he taught the curator of the topic when it was - but he did not understand why this file)

Full version    

Help     rules

Now: 05.12.20, 12:09