D_Devil @ 08.12.16, 13:59
Has someone already come across to reflash attached to Kyivstar?
Yes. I reflash. A programmer is not required, but you cannot do without the console and replacing the boot first, and then the firmware from the tp-link, without checking the firmware identifier. Everything about everything took 30 minutes.
On the board we find J3 place for the console connector. 1 (square hole) Tx router, 2 - Rx router, 3 - GND
putti. speed 115200 8n1
we read
this threadswing
from herefrom the folder china_uboot_ (best) u-boot-qca953x.bin
next turn on the router. we get through the console to boot and strictly enforce this command sequence (of course, the computer and the router must be connected to the Ethernet cable and the tftp server must be raised on the computer.)
tftpboot 0x81000000 u-boot-qca953x.bin
erase 0x9f000000 + 0x20000
cp.b 0x81000000 0x9f000000 0x20000
bootm 0x9f000000
Reboot. In theory, the boot has changed. Check is very simple. Turning off the power, holding down the reset button, powering up and looking at the console message that you can connect to the router at 192.168.1.1 and through the web interface there is not a lot of mess around in the buta.
Download from the site TP-link firmware. In the settings of the boot, we change the MAC and PIN to Wi-Fi. choose upgrade firmware. fill in the firmware merged from the tplink site. wait a couple of minutes. the router will do everything by itself. You can complete the process through the console.
You can use. One nuance. after replacing the boot, the power indicator turns off. It can be fixed simply. go to the web interface of the router and in the firmware replacement section re-pour the firmware from the Tlink website. In this case, the boot is worn on the motherboard from the tplinka. The power indicator will start to work. Actually everything ...;)
Post has been editedhawkman - 20.12.16, 23:40