Collect bin (dump) for the programmer | [firmware]
solamon9, Successes DumpOpenwrtA dump will allow you to raise the router and then sew it up with native firmware
Manufacturer: Zyxel
Model: Keenetic
Version: rev.A
CPU: Ralink RT3052F
DDR: Winbond W9812G6JH-6
Flash: MX29LV640EBT (8 MB)
dump_keneetic_rev_A.zip(3.8 MB): to_clue:
 |
diassxak I have a 4mb flash Attached images
 |
Post has been editedsolamon9 - 21.03.18, 07:41
Reason for editing: Added a photo of the board
solamon9, Solamon9 @ 03/21/18, 06:12
Is keneetic and keneetik 4g compatible?
There is only rev.B
18001_Keenetic4GB2.rar(3.96 MB)CPU: ?
DDR: ?
Flash: ?
Diassxak @ 03/22/18, 11:02
CPU:?
DDR:?
Flash:?
DDR:?
Flash:?
CPU: RT3050 (320MHz)
DDR: RAM EM63A165TS-6G (16bit 32MB)
FLASH: MX29LV320DTTI-70G (4MB)
solamon9, Keenetic rev
Keenetic: CPU: RT3052 MIPS24Kc @ 384MHz Flash: 8MB RAM: SDRAM 32bit 32MB
WLAN: Built in SoC 2T2R / 300Mbps (2.4GHz) Switch: 5x100MbE with HW_NAT v1 USB: 1x2.0
Keenetic giga : CPU: RT3052 MIPS24Kc @ 384MHz Flash: 8MB RAM: SDRAM 32bit 64MB
WLAN: Built in SoC 2T2R / 300Mbps (2.4GHz) Switch: 5x1GbE with HW_NAT v1 USB: 2x2.0
Keenetic Lite Rev. A: CPU: RT3050 MIPS24Kc @ 320MHz Flash: 4MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 5x100MbE with HW_NAT v1
Keenetic 4G Rev. A: CPU: RT3050 MIPS24Kc @ 320MHz Flash: 4MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 3x100MbE with HW_NAT v1 USB: 1x2.0
Keenetic Lite Rev.B: CPU: RT5350 MIPS24Kc @ 360MHz Flash: 8MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 5x100MbE w / o HW_NAT
Keenetic 4G Rev.B: CPU: RT5350 MIPS24Kc @ 360MHz Flash: 8MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 3x100MbE w / o HW_NAT USB: 1x2.0
WLAN: Built in SoC 2T2R / 300Mbps (2.4GHz) Switch: 5x100MbE with HW_NAT v1 USB: 1x2.0
Keenetic giga : CPU: RT3052 MIPS24Kc @ 384MHz Flash: 8MB RAM: SDRAM 32bit 64MB
WLAN: Built in SoC 2T2R / 300Mbps (2.4GHz) Switch: 5x1GbE with HW_NAT v1 USB: 2x2.0
Keenetic Lite Rev. A: CPU: RT3050 MIPS24Kc @ 320MHz Flash: 4MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 5x100MbE with HW_NAT v1
 |
Keenetic 4G Rev. A: CPU: RT3050 MIPS24Kc @ 320MHz Flash: 4MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 3x100MbE with HW_NAT v1 USB: 1x2.0
Keenetic Lite Rev.B: CPU: RT5350 MIPS24Kc @ 360MHz Flash: 8MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 5x100MbE w / o HW_NAT
Keenetic 4G Rev.B: CPU: RT5350 MIPS24Kc @ 360MHz Flash: 8MB RAM: SDRAM 16bit 32MB
WLAN: Built in SoC 1T1R / 150Mbps (2.4GHz) Switch: 3x100MbE w / o HW_NAT USB: 1x2.0
Try to sew it
ZYXEL-Keenetic Lite A.1.rar(3.36 MB)Good day! Please share if someone has Full dump on the D-link DIR-615 / D / P1A processor MT7620N flash cfeon q32b-104hip
Post has been editedarion537 - 02.05.18, 01:37
Post has been editedarion537 - 02.05.18, 01:37
Fudjest @ 04/21/18, 9:24 PM
Does anyone have a wr740n v6 dump?
No
there is
TL-WR740N Rev 4.21
TL-WR841N (ND) V8.1
WR740N v5 full dump (fullflash)
Posted on 05/03/2018, 12:29:
[email protected], 23:54
D-link DIR-615 / D / P1A
rev. ???
Full dump on D-link DIR-615 / D / P1A
full dump D-Link DIR-615 p1 v2.5.15.7z(3.64 MB)Posted on 05/07/2018, 10:57:
arion537, sergejb52, TRENDnet TEW-639GR V2.1R
Full firmware dump.
Firmware Version 2.0.0.82
Ralink rt3052
ST 25P32V6P
TEW-639GR.zip(3.17 MB)http://forum.ixbt.com/topic.cgi?id=14:63550
Post has been editeddiassxak - 07.05.18, 11:05
Diassxak @ 05/05/18, 10:56
full dump D-Link DIR-615 p1 v2.5.15.7z (3.64 MB)
This is a complete lady from the flash drive, is it with the bootloader?
diassxak , Thank. I requested it but the router did not come to life, but it behaves differently. Immediately before the firmware, he did not go into the settings and did not reset them, the power lamp was on and the lan lamp in which he connected the wire. The wlan light did not light up and the wps button when pressed, also did not light. Now the power is on, lan, wlan, and wps is working. A WI fi network appeared with the name test, but it also does not connect, the settings are not reset, and there is no Internet if you connect a cable. Where else can I dig?  |
 |
Post has been editedarion537 - 07.05.18, 14:35
Reason for editing: Added photo
©savagemessiahzine.com2005-2020 All rights reserved.
savagemessiahzine.com®- registered trademark.
Terms of Use | Denial of responsibility | Advertising placement
savagemessiahzine.com®- registered trademark.
Terms of Use | Denial of responsibility | Advertising placement