> Attention!

Creating topics in this section is not available. If you haven't found a discussion of your problem in this section, you can create a topic inmain section.



Error 4013 when restoring | [ITunes]



Rep: (1)
iPhone 4s 4013 error when restoring

iPhone 4s 16Gb PCT
Firmware: iOS 7.1

Jailbreak : Not
Description of the problem:
Good afternoon. The phone was off regularly in the charged state, after which it stopped turning on. When you try to turn on: the screen with the logo flashes periodically. Indication of low charge, but not charging from the network or from the computer. The cable is original.


There have been actions:
When trying to restore from Recovery mode = error 4013. DFU = similarly. In both modes, itunes sees the phone in recovery mode, but the process is interrupted with the indicated error. Now when you turn on (or connect to the charger), the phone immediately shows Recovery mode. Unambiguously service or still compete?




Rep: (26)
5s Located screen, apple and reboot, error 4013 by 20 percent of the firmware ... Question: Is it fashionable to flash the board with the battery, the interface connector and the button, without all the rest of the pribluda?



Rep: (0)
Hello to all!
I have such an iPhone 6S Plus problem after replacing the battery. Cyclic reboot. You can update (turning off all the plumes.
But after he still restart all the time.
Who faced the help - advice!

No caution did not make backup and now the hostage of the circumstances!

I would be grateful for any help



Rep: (9)
Now exactly such a problem with the 6th, the specialists said to raise the NAND and rip



Rep: (0)
How could Nand Nand fall off when replacing the battery + it is updated via iTunes. When removing 2 of 3 loops



Rep: (9)
Battery replacement is just a coincidence.



Rep: (0)
Coincidence of the myth for the uninitiated.

It passes the update completely - without errors!

The error gives only when the sensor sensor and camera loops are connected (updated with the screen)



Rep: (9)
So the problem with the reboot indicates the death of NAND + error 4013.



Rep: (0)
Hello everyone, I share personal experience, I hope to someone help someone.
My iPhone 5S 16GB served me by faith and truth since 2014, of course during this time I had to replace the battery and in a sad chance. In short, one day, when landing it on a recharge cable, he stopped charging, although the battery charge shown on the screen, but the battery did not charge. As a result, the phone was discharged and I was sin on the battery, postponed him in the box, waiting for the delivery of a new one ... In one beautiful, sunny - summer day, I became bored and I decided to return to my life of my faithful friend, completely forgot about the root of the problem . In general, I threw it to his PC and about the miracle, he is determined by the tuna and offers me the possibility of updating or recovery, but both options give out an error 4013. Wheel in search of the error number and clicking on the link to the branch. This is a wonderful forum, I began to read folk methods for freezing Phone in Germ. Package or warming of NAND memory and, accordingly, implementing them in your California friend. I had to suffer all the same, straight the song of ice and flames))) For a long time I spent experiments on the iron - a lifeless body, but still a sip of life was inspired and a new mistake is swimming on the tuna screen, which served as an impetus to restoration, honestly I do not remember which error number was but he led me to the 3Tools program. By downloading it, I connected the body to the PC, the program immediately determined and offered to download Off. Firmware or select from the folder if it has already been downloaded. By pressing the magic button "Firmware", the process went on notes and after about 30 days of approximate time the phone again breathed a new life from a clean sheet. But the original problem remained as if leeches. After breaking and collecting it along the screws, since so 15, the problem was detected, namely the power controller that served a current on the 1mA battery when it should produce 4.0 - 4.5.
Be careful and success in repair ;-)

Post has been editedMaxWell27 - 29.07.20, 19:01



Rep: (0)
it was but the master said nothing



Rep: (16)
Patient iPhone 6 Plus. Was a dead battery (bought a new one, but turned out to be a marriage) and periodically rebuilt by 40-50%
I ordered a new, while I waited for such an incident - stood on charging in modem mode and suddenly began to restart, rebounded before unlocking, entered the password and again the reboot. Okay, I think in batteries already, I waited, I changed it, and all the same, but already the reboot on the apple endless. I tried to reflash and error 4013, freezing and TP tried. In the SC, they told repairs in the area of ​​2500, but to give so much for the phone that stands on the secondary in the range of 6000 - I consider it inexpedient. Maybe someone else can advise any ways to raise it from the next world?



Rep: (0)
I decided to shoot under the water on the iPhone 11, the phone is rubbed. Now I have a lope reboot and when restoring an error 4013, occasionally turns on, and if the main thing is not turned on) the freezer helped 2 out of 5 attempts, but I think more coincidence.



Rep: (93)
Brought iPad2. Began to update and the same error. Updated on the laptop. Tormented, in any. I connected to the computer in USB 2.0 and everything was updated. There are no real 2.0 on the laptops, there is an emulation from the 3.0 concentrator.



Rep: (0)
Can someone service in Kiev recommend? Tried all the described options with Ipad 2018, in any way, 4013 and everything = (



Rep: (40)
* trem4eg , the price of repairs will not be justified, sent its 7+ for three offices - two refused, the third charged the price where it was possible to choose, or repair, or 7+ used, not even restored ...


Full version    

Help     rules

Now: 12.12.20, 13:46