Cover overview
Ringke Fision X Price for
Ebay- 763 rubles
Ringke Fusion X's brutal case, suddenly became my favorite case. In the pictures it seems that it is cumbersome, but in reality it turned out to be only a little more than the Spigen case. And due to the thin back wall, in the hand the Ringke phone feels even thinner than it was in the Spigen case.
Ringke and Spigen Case Size Comparison
Photo cover Ringke Fusion X on your phone
On the packaging it says that the defense of this case meets the military standard of the country of our potential enemy. Feels like, cover and really very reliable. Frame probably made of polyethylene (similar to plastic, but it is flexible and much tougher rubber). Top frame projects above the protective glass Imak, and protrudes from the bottom inside the rear wall. In all corners of the frame are made shockproof thickening. Which, incidentally, appear and the bottom too, so that the phone lying on the table, do not concern the entire surface, but only barely four protruding legs, as it were, standing on four legs. The rear wall is made of a transparent rigid plastic (and by the way, from the packaging, it was carefully glued protective film on both sides, so as not to scratch the sorting and transportation).
Case compatible with protective glassImak pro . On the case, on the bottom of the left side there is a loop for the lace. The cutout for the fingerprint scanner has a beveled edge (not as steep as in the Spigen case, but also comfortable enough) so that it is easy for the finger to find the scanner and not confuse it with the camera. The power button is pressed easily. The volume buttons (I wanted to write that they are pressed tightly, but these touch buttons can adjust to something?) After a day they suddenly began to be pressed normally. By the way, with this case
involuntary pressing of volume buttons disappeared that happened spontaneously when I pressed my fingers on different parts of the body. The side faces are compressed much harder than without a cover, you have to push hard, but I'm used to it. At first, I didn’t even always succeed in squeezing the edges, but it turned out that it was necessary to press NOT on the lower half of the phone, but above, right under the power button, compression works easier here.
In general, the case looks very cool, it is immediately clear that the phone is male. Reliability is felt throughout. It even seems that the phone can now be thrown, and it will not be anything. And this lack of fear of hurting him is a very pleasant feeling. It looks like this case will be worn constantly.
Post has been editedSLA8 - 24.04.19, 16:45