I redid a table for fastening at 3 points, quite thoroughly came out, I did it while on the ambulance hand to check the performance of the idea. According to the results, I am very pleased, it is very simple to calibrate, now nothing fuses and does not pull! Now reprinted fastening model, I will add rigid rigidity there, well, and some moments a little remake, but mostly everything will remain as in the photo. What about the curve table, found out that the aluminum leaf is wounded below, when heated, the table becomes perfectly smooth. That is, aluminum him in the corners is tightened, he just glued in the corners, it would be some kind of soft, to spare it now, just to fix it on the brackets, I also stuck it from the corners (.
A photo.
Model typing standing on her side, so that it was stronger, as it was badly imprinted without support.
As a gasket, electrical paper, the corner is very hard, not aluminum, dural.
From the side of the side, the head does not reach the edge of the floor centimeter, at the end of the print, when the table leaves does not cling.
The other day I will buy 7 melamine sponges, they are very light, they will be used as thermal insulation, sticking, and on top of the foil, too, for silicone.
First printed without thermal insulation, then pasted the cardboard, the temperature began to gain faster, and less often heated, that is, I facilitate the life of the power supply, now the cardboard was removed because of the modernization, and the difference is noticeable straight, heats longer, the heating turns on more often, and the printer itself All that is hot becomes.
Clawhammer2007 @ 04/23/19, 09:26
It is necessary to change the springs on hard poliet and there will be no bending of tables
Did you try to shoot these springs? They are very tough.
Post has been editedAlexfrog. - 23.04.19, 08:51