And so, the Stub - Moza Mini Me (the only thing that is now the old one that holds the weight of more than 200g. Or rather somewhere 250).
To begin with, we dug a rubber sticker from a wireless charging on the phone holder and cancel the induction coil. It does not affect charging, but gives the place to our puzate friend :)
Folding the phone should be slightly in the back of the fingerprint scanner. What would have been charging (but you can not charge).
Balancer - Nut from the battery, and stuck on a thermoclay, whatever stubs:) inside two washers. I do not remember what diameter, smoked by weight. Balancer put up in the middle, climbed the phone under the fingerprint, then the method of tyk. So we unload the central axis from the overload, otherwise burns.
Then we set up the Stub himself, under the fact that you need, the capacity everywhere put 40% sometimes I put 50-60. If something is active.
We put the smartphone into the mount just between the camera button and the combs on off.
Something like this :) The very collective farm is just with cargo)) Since the phone is shifted to the left / right due to cameras in the center, therefore there would be no chambers closer to the edge, then the cargo should not hang extra.
Motors pull and so.
But alas here, you have to conjure a bit.
Stabilize as I think who will use the Stab, already knows. We put on the leg included, and the phone should hang on the axis horizontally. Slightly behind the edge pull down and it should return to its original position, horizontally.