A.r.c.h.e.r., Stitched, as indicated in the instructions.
factory-to-ddwrt.bin - file for installing DD-WRT from under the router’s native firmware.
webflash.bin - file for updating from the already installed DD-WRT.
For some models, only one file is available for all operations.
For initial installation of DD-WRT:
In the address bar of the browser we type
http://192.168.1.1or
http://192.168.0.1, depends on the router, enter the authorization data and update the factory-to-ddwrt.bin file through the standard update menu in your router.
After some time, the router will reboot, after which you will see the updated interface (DD-WRT's address is 192.168.1.1 by default). On the main page when you first start you need to specify the username and password for administration.
Firmware dd-wrt installed, you can proceed to configure. (It is also recommended to do a reset to the factory settings after the firmware and before the setting)
If you have problems with the inability to log into the DD-WRT admin panel after the firmware, go to the network connections on your computer and make sure that the IP addresses are issued correctly: ip: 192.168.1.xxx (the last digit may vary) mask: 255.255.255.0 gateway: 192.168.1.1. If the addresses are different, then the easiest option is to restart the network card (on and off, then the network will again ask for addresses via dhcp), if this does not help, enter manually, for example ip 192.168.1.2, mask: 255.255.255.0 gateway: 192.168. 1.1 and try again logging in to the browser at 192.168.1.1.
To update an already installed DD-WRT:
In the DD-WRT menu, select “Administration” - in the submenu, select the item “Firmware upgrade”. Click on the “select file” button and specify the webflash.bin firmware that you downloaded earlier. Click on the “Upgrade” button, the software update process will begin.
Link tosavagemessiahzine.com.
DD-WRT - alternative firmwareTried to recover according to this instruction.
https://proadminz.ru/v...ki-tp-link-tl-wr842nd/