How to sew android Oreo beta of 20171124
Immediately I warn, during the time of firmware from the phone to delete all data. Therefore, slowly and surely we do a backup.
And so, how to sew on Win 7 (x64):
1. Downloading firmware Oreo beta here
Coolpad Cool Play 6 - Discussion (Post HighwayStar # 70750405)2. Downloading Coolpad Download Assistant V1.94_170421, ADB and drivers here
LeEco Cool1 - Firmware EUI / JUI (Post Cusco # 75654247)section of drivers and utilities.
3. Set Coolpad Download Assistant
4. Extract Desktop firmware.
5. Make a thorough cleaning. This is necessary in order to remove the influence of the factor settings or applications you have installed.
In the phone: "Settings", "Advanced Settings", "Backup and Recovery", "Restore Factory Settings", "Reset".
6. Switch the phone in Fastboot mode. Namely, disable, wait until the shutdown, then we press the "Volume -" button and click "Enable"
(It is possible and through the ADB. Connect your phone to a computer. Run it and enter the command adb reboot fastboot)
7. Connect your phone should be tightened driver if the device appears not so, then it means that the driver is not pulled, the demolition of it and install needed.
8. Run Coolpad Download Assistant.
9. Select the firmware file
10. We wait until the file conversion
11. Connect your phone in fastboot mode
12. He should start sewn
13. At the end of the firmware in the program the green smiley face will appear and the phone will be with the new firmware.