Restoring the unit killed.You need an unlocked bootloader included factory razblokirovaka, micro SD card formatted in exFAT.
To restore the firmware to use any version
your firmware ,
your firmware - means that the location is used to restore the firmware should be the same as that of the firmware installed in your device (before you broke the machine).
Version must be taken FullOTA.
Example
C10 = C10 so perfectly,
S432 = S432 so perfectly, S636 = S432
is unacceptable , L09 = L29 do not try - can earn maybe not :)
How and where to get the parts BOOT.img, CUST.img, RECOVERY.img, SYSTEM.img see
hereFor Chinese firmware TWRP and customrecovery.img - should have their own !!All three of the tether must be from one of your firmware !!!Restoring Data sectionTo do this, do the following:
1. Install TWRP (set instead eRecovery)
2. sewn update_full_VTR-Lhh_hw_hh.zip (previously removed therefrom UPDATE.APP) and update_data_full_public.zip
your firmwareWithout rebooting, one after the other, the former may give the error is normal.
Restoring the system:
3. sewn parts (sections)
your firmwareusing point в„–6 "raskirpichivanie" program
HUAWEI Multi-Tool.
To restore the program will need the following sections of your firmware BOOT.img, CUST.img, RECOVERY.img, SYSTEM.img, put the files in the folder you need to \ Huawei_Multi-Tool_by_Team_MT \ Unbrick.
4. Make a reset to factory settings is possible through the Setup menu or the official Recovery.
5. Load the machine check the availability of all program audio performance and so on.
If it works there's nothing else to do unnecessaryIf not go to step 6.
6. customrecovery.img worthy of customrecovery.zip and set instead of the main rekaveri.
customrecovery.zip(39.57 MB)
fastboot flash recovery customrecovery.img
7. Remove from the file update.zip update.app your firmware, put it in a folder dload, micro SD card.
8. Before restarting the machine, place the micro SD card into the machine.
9. Disconnect the USB - cable and hold the vol + / vol- 5 - 10 seconds (or until you see the message "this device can not be trusted"), wait for the start of the update system. The update should reach 100%
10. Make a reset to factory settings is possible through the Setup menu or the official Recovery.
All you now have fully restored the firmware device.In this method, you can update the device, but because of the complexity of the method, I do not recommend it.Post has been editedyury_z - 08.05.17, 06:40