897654,
those. Strike then recovery with firmware? Or what did you advise a bud?

In the correct question, there is already half a response.
Though you write if the phone was stitched, whether the TVP installed, custom recovery, root.
Does it comes to the recovery in general.

Post has been edited897654 - 15.06.16, 22:01

Put any recovery, then sew the firmware out of it

the phone never stitched and did not put the ruth recovery and all that

Through the Flashtula, you only flash the recovery TWRP, you throw off the firmware for the recovery on the flash drive, then you load the body into the recovery, you find the firmware and flash, load into the system, copy everything you need to copy to the computer. The main wipe do not.

Post has been editedBuhoyy - 15.06.16, 22:05

Buhoyy,
How to put recovery too through a flash station?

Here everything is shownHomtom HT7 Pro - Firmware (post alex12714 # 49363434)
Do not be lazy to read the cap.

Post has been edited897654 - 15.06.16, 22:07

Buhoyy,
Ok understood the past right now I shake

Read carefully, I wrote, put only the recovery through Flashtula

Posted on 06/15/2016, 22:09:

After all actions, I still recommend to flash the stock firmware through the flashlight with all the wipes and you will be glad)

Buhoyy,
It seems with firewood I have a problem

How to make a computer to determine the phone turned off normally, then only all times only TWRP, then you go to it and mount those sections from which you need information, and then you turn on the file manager and copy the folders to the USB flash drive, pull out the USB flash drive And on the computer you check whether everything you need copied ... Next to your discretion, or put the firmware you like through the Wipes (except for the flash drive), or through the flashlight full firmware

SAMZVER,
I want to sew TWRP, but it does not work

SAMZVER,

Post has been editedolegusss - 16.06.16, 15:18

Can't put drivers? Try with disconnection of verification of driver signature (easy to google and almost in any branch in this forum there are instructions, in this topic there are allSP_Flash_Tool is the flash driver for MTK smartphones.and remove drivers and install them and how to disable signatures)

Alpanvi,
So Yeshkin cat ... you have drivers stand, try to sew !!! You run the flash drive, select a scant (better place the scant and TWRP in a separate folder), check the path to the recovery and have no extra checkboxes (when you select a file of a file from a separate folder in which there is nothing more than it and TWRP is no longer prescribed and only after that connect the disconnected phone, then it should go firmware which takes seconds 3 if it sews only recovery

Posted on 06/15/2016, 23:17:


I have not tried, but it seems like you can ...

Posted on 06/15/2016, 23:19:

Alpanvi,
If all that I wrote above does not work out, then try to change the version of the flash, if it does not help, then delete the driver from the system and try to renovate

SAMZVER,
I change flasht
Now Scatter Fail Failed
Last Flashtool did his job

By the way, the problem with the LED, the Chinese in the last firmware decided (even when notification comes). At least, everything works fine for me. It is a pity that it reduces chances to get Android 6.0

Post has been editedvaalf - 02.09.16, 20:55

I put the stock of the recovery through the flash station like everything was fine, but when I go to the recovery viberates, I eat a picture what to do?

Post has been editedolegusss - 16.06.16, 15:19

Jasch again on and + volume

Post has been editedolegusss - 16.06.16, 15:19