Assistant
REPLY |
ESCAM QF002 IP Camera - Discussion | [ip camera] 720p, P / T, WIFI, IR LED |
Message#1 23.03.16, 12:56 | ||
Guru [offline] Group: Friendssavagemessiahzine.com Messages 3702 Check in: 11.04.14 Lenovo P2 4/64 Reputation: 116 | ESCAM QF002 - Discussion [ip camera] 720p Wi-Fi camera with IR illumination for ~ $ 30-40. Discussion � Firmware Off firmware General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20170215_ALL- firmware from 02/15/2017 ONVIF Firmware General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20161024_ALL.bin- firmware from 10/24/2016 (maybe not of firmware) General_HZXM_IPC_HI3518E_50H10L_S38_V4.02.R12.Nat.OnvifS.20160615_ALL.rar(6.58 MB) - firmware from 06/15/2016(unverified, if anyone dares to check - write down the result) General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20160520_ALL.rar(6.39 MB) - firmware from 05/20/2016 General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20160307_ALL.rar(6.35 MB) + Mirror- firmware from 03/07/2016 General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20160219_ALL.rar(6.35 MB) + Mirror- firmware from 02.19.2016 Firmware catalogunverified General_HZXM_IPC_HI3518E_50H10L_S38_V4.02.R12.20150116_ALL.rar(6.81 MB) - firmware from 01/16/2015 General_HZXM_IPC_HI3518E_RA50H10L_S38_V4.02.R12.20141209_ALL.rar(6.82 MB) - firmware from 12/09/2014 useful links Product page on the manufacturer's websiteortyts Disassembly and installation of rad-ra Configure RTSP streamandhereandhere Traffic consumption connect to camera viaTelnet If you get offtimeafter power off Recoveryafter unsuccessful firmware (addition: the camera must be connected not only via Uart, but also to the router with a network cable!) Microphone hissing Instructions Setting up the camera through no-ip Instructions in English - Instructions for setting up sending emails: motion + detection.doc(684 KB) IMPORTANT!, if not helped, then readhere Video instructionhow to set up a photo with an alarm and write it to a memory card Video instructionon setting up a motion sensor instructionto xmeye Video samples Customers Equipment - ESCAM QF002 camera - Power supply 5V 2A (with plug: EU / UK / AU / US) - USB cable - Red ceiling mounting - Dowel mount - Clip - Instruction (in english in doc)
There is no curator in the subject. For questions about filling the caps, please contact the section moderators via the buttonunder the messages to which you want to add links. Post has been editedmihadom - 16.11.18, 17:07 Reason for editing: standardized section | |
Message#1202 11.03.19, 12:53 | |
a guest [offline] Group: Users Messages 2 Check in: 16.01.19 Reputation: 0 | Gentlemen, is there no way to tie this camera to mi home or Yi home? |
Message#1203 21.03.19, 21:00 | ||
a guest [offline] Group: Users Messages 8 Check in: 27.03.14 Reputation: 0 | Hi, please tell me, I have 3 days not working 1 camera QF002 in the Xmeye mobile application via the Internet Explorer browser on the Xmeye website and in the VMS application on the computer everything works great Can anyone know what the problem is? Post has been editedBibikf1974 - 21.03.19, 21:26 | |
Message#1204 22.03.19, 04:22 | |
Local [offline] Group: Friendssavagemessiahzine.com Messages 327 Check in: 15.12.11 Lenovo Vibe X3 Reputation: 24 | |
Message#1205 22.03.19, 07:27 | |
a guest [offline] Group: Users Messages 8 Check in: 27.03.14 Reputation: 0 | Hi, the fact is that on my Mi8 the camera doesn’t work, I didn’t try to reinstall the app, but my wife also had glitches on Mi 5 but then it all worked well! Then why does it work on mi5 and not on mi8 that’s the question !!! Maybe they have some glitches on the server? |
Message#1206 24.03.19, 19:09 | |
a guest [offline] Group: Users Messages 8 Check in: 27.03.14 Reputation: 0 | Hi, I just did not try as soon as I wasn’t izgolyalsya, and the casket just opens !!! Removed the Xmeye folder and restarted the application, the program created a new one and it all worked !!! |
Message#1207 05.04.19, 17:52 | |
User [offline] Group: Friendssavagemessiahzine.com Messages 82 Check in: 24.07.13 Lenovo P780 Reputation: 0 | ESCAM QF003 Camera. He does not want to go over WiFi. When you try to reset, the settings are reset, it reboots, but does not give sound messages. In Setup - System - Network Services - Wi-Fi does not see networks. Where to dig? Post has been editedCool_lamer - 05.04.19, 17:55 |
Message#1208 06.04.19, 15:10 | |
Local [offline] Group: Friendssavagemessiahzine.com Messages 172 Check in: 18.02.11 Reputation: 1 | Where can I buy a motherboard for this camera? Has ceased to work and does not see on the local network. When connected to the mains, a couple of diodes of infrared illumination weakly burn. Posted on 04/06/2019 at 15:14: Almost the same problem |
Message#1209 07.04.19, 17:59 | |
Local [offline] Group: Friendssavagemessiahzine.com Messages 172 Check in: 18.02.11 Reputation: 1 | [email protected], 14:59 I put a new motherboard sent by IPC-RB 18EVBLK-XST V1.01 servants Tell me where this board was ordered, but then I died like that? |
Message#1210 08.04.19, 04:54 | |
User [offline] Group: Friendssavagemessiahzine.com Messages 82 Check in: 24.07.13 Lenovo P780 Reputation: 0 | I did not understand how to set up a motion recording on it. If you remove the checkbox "Post." Post has been editedCool_lamer - 08.04.19, 04:58 |
Message#1211 08.04.19, 07:09 | |
Local [offline] Group: Friendssavagemessiahzine.com Messages 210 Check in: 18.11.11 Reputation: 9 | Read the cap in it is all written. |
Message#1212 08.04.19, 12:07 | |
User [offline] Group: Friendssavagemessiahzine.com Messages 82 Check in: 24.07.13 Lenovo P780 Reputation: 0 | |
Message#1213 24.04.19, 10:50 | |
a guest [offline] Group: Users Messages 1 Check in: 16.02.15 Reputation: 0 | Flashed firmware, the boot process stops at this Uncompressing Linux ... done, booting the kernel The camera does not appear on the network, does not respond to the button. I'm trying to flash General_HZXM_IPC_HI3518E_RA50H10L_8188_S38_V4.02.R12.Nat.20170215_ALL. run dw, du and dc work fine. When started, run dr says that the flash is write protected. run da is similar. xmtech # run dr Hisilicon ETH net controler MAC: 00-12-17-30-2D-45 eth0: phy status change: LINK = UP: DUPLEX = FULL: SPEED = 100M TFTP from server 192.168.1.1; our IP address is 192.168.1.10 Download Filename 'romfs-x.cramfs.img'. Download to address: 0x82000000 Downloading: ################################################ # done Bytes transferred = 3588160 (36c040 hex) 8192 KiB hi_fmc at 0: 0 is now current device Can't write to protected Flash sectors I tried sf unlock all, sf lock level (0), sf lock 0 to any commands the answer is one - "sf - SPI flash sub-system". help sf is similar. Before the experiments, I saved a dump by the programmer. I found the location of "romfs-x.cramfs.img" in the dump on the line "Compressed ROMFS" and replaced it with a file from the firmware. I do not see any changes. What else to try? |
Message#1214 24.04.19, 12:23 | |
a guest [offline] Group: Users Messages 3 Check in: 08.10.14 LG Optimus Hub Reputation: 0 | Guys help me understand what happened to the camera. Recently, I started to show badly at night, and then stopped responding to actions in the application, I now took it off and wanted to reinstall it, I’d do a reset (press) and click the reset button, but the voice doesn’t say anything I do not see the camera. I checked the power coming up to the camera. What can I do next? I’ll turn on the device. When I plug in the network and close the LED, the LEDs light up and everything, through the computer, the program doesn’t see the camera program |
Message#1215 26.04.19, 22:35 | |
Visitor [offline] Group: Active users Messages 15 Check in: 01.07.11 HTC Desire S Reputation: 0 | Good afternoon, guys, please tell me, the camera has stopped seeing wifi. We don’t find any router, the latest firmware version. After resetting the parameters, it says that it is waiting for the connection and that's it ... There is no problem with the cable. Maybe someone came across?! ??? |
Message#1216 26.04.19, 22:48 | |
Visitor [offline] Group: Active users Messages 15 Check in: 01.07.11 HTC Desire S Reputation: 0 | |
mobile version | Now: 02.05.19, 04:10 |