So! I raised my brick! How killed is described
hereSince our service dismissed from him with his hands, I decided to experiment.
I hope the local guru will correct me if something is wrong or I will write (with android a month is familiar).
And so the problem is:
Killed on the phone bootloader. The phone does not connect to the computer. Firmware, recovery, etc. Do not load. BRICK.
I'll say that
The restoration is lost warrantybecause, breaks down a seal!
How to recover:
1 Charge a couple of hours. The battery.
2 Disconnect the USB string from the computer and the phone.
3 Remove the lid.
4 Remove and remove the NFS module - 9 bolts (centered seal - there is also a bolt)
5 Turn off the loop of the battery, it is left. (I stuck it with a tape, so that I would not close)
We will flash without a battery!6 Connect the USB lace to the phone.
I do not connect the computer yet.7 closure two contacts on the right tweezers and keep (in the picture circled 2)
8 We connect the USB cord to the computer and wait until the COM10 does not exist in the device manager.
Sometimes you still have to press PWR + VOL- not releasing the contacts to turn on the phone.
And then like through the EDL - the last version of Miflash.
Sew to start the Chinese firmware version
My phone works, in FastBoot comes, well, and then on the rolled out :)
Post has been editeddraiv88 - 12.07.16, 23:29