And I slag myself like this "super" engineering cable for the firmware of the device in
anyHis condition.
For this method- (starting by: "The firmware process:" and below). Works!
Make it yourself - elementary.
Understandable to all words: carefully cut the shell, get the necessary two veins - black and green, clean them without breaking and attaching a button to closure to them, re-insulate again.
If you are road devices and a computer,
I highly recommendAny kind of temporary jumper bugs on the USB housing connector. This is not always a general "minus", and most often the "screen" of the device may be isolated.
Alternative (for lazy people) Method, without soldering and buttons - just clean the small site of the specified lived (without breaking) and closer at the time of connection, then breed (the Qualcomm port must appear .com **) and sew through Miflash. From the developments,
important: 1. Use the proven Xiaomiflash-Beta (in the header
link); 2. Be sure to set the "Clean All" in the Miflash.
Everything!
P.S.: If not working: You can not exclude the option of a kosyachka cable, as not the right moment of connection. If the device is completely turned off when connected when connected, then there is no short-circuited state between the conductors (Data + and GND) and it will be necessary to try to connect several times, to achieve a state without indicating charging, but only then disconnect the wires, or release the button. A port should appear as on the second screen (Qualcomm HS-USB QDLoader 9008 (COM #).
In my practice there were cables, from our brothers, any configuration. There was no wire that did not fit the wiring in colors, and sometimes there are other colors. In this case, the tester to help you. But this is the top of the skill! : Beee :: rofl:
Post has been editedAnatolDv - 15.12.16, 15:26Reason for editing: Explanations