Nurlan82 @ 05.05.2015, 12:50
Qualcomm HS-USB QDLoader 9008 (COM5)
A small instruction, how to return to the life of "brick" when determining it on a PC
Qualcomm HS-USB QDLoader 9008 (Qhsusb_bulk) How to enter your phone in this mode (download) yourself:
a. Turn off the device, then cluster the volume + and - (both keys) and connect the USB cable to the PC.
or...
b. Loading in Preloader, holding [vol +] and press [POW], then press the "download" button in it.
There are cases and worse ... There is such an option for this:
c. Remove the battery, then you clush the volume + and - (both keys) and, without releasing them, connect the USB cable to the PC and insert the battery to place.
All options are checked.
If Windows 7.8 or 10 is installed, then you must definitely disable driver signature check !!! Looking for online how to do it.One shutdown option ...
How to Make: Parameters ->Change computer settings ->Upgrade and Repair ->Recovery ->Special download options ->Reload now.
After: Diagnostics ->Extra options ->Boot Parameters ->Reboot.
After rebooting, press the F7 key on the keyboard, i.e. Disable mandatory verification of driver signature.
And so download
Miflash.and install on the PC,
as well as drivers for
QUALCOMMIn the event that an unknown device in the device manager
QHSUSB_BULK . PC has not yet defined it as COM port named
Qualcomm HS-USB QDLoader 9008 .
Download FastBoot Rom Firmware for your model
HERE, transferring it to the C: / right to the root and unpack (better than WinRar Lkm - Extract to the current folder)
Connect your phone to a PC via USB.
Run the Miflash application on behalf of the administrator ...
and then carefully all
ThisInstructions, only in the device program will display a COM port with its number. Yes, and most importantly, choose only
flash_all.bat .
If the firmware process is completed, the phone itself will boot.
If
Miflash completed the work successfullyBut the phone does not boot, disconnect it from the PC, remove and paste the battery back and turn on the device.
Another interesting point, described by akzhol_b
Akzhol_B @ 08/24/2015, 17:46
I "revived" your phone.
The phone could not go to the FastBoot, Boot, LED charging did not turn on.
Through QFil, Miflash (Hello Packet Error) did not pass the firmware.
Decision:
1. Pull out the battery and insert.
2. Before the firmware will put the phone for charging (30 seconds at least). Hike, at this point the USB port starts to work normally
3. I firm through Miflash.
3a.If at the first attempt did not work, then back to 1 point.
The instruction is checked for several users from the forum.Post has been editedbrigudav - 06.11.16, 03:54Reason for editing: corrections based on the results of the recovery of formula