[X]Assistant

[Macintosh26]

Explay Fog - Firmware (OS 4.2.2 - 4.4.2)
Explay fog
Description | Discussion пїЅ | FirmwareпїЅ

Drivers and Utilities

Phoenixsuite

Official firmware

Official firmware
mirror

Unofficial firmware

Firmware with Irbis [4.2.2 Jealy Bean]
Firmware with Digma Optima 7.8 [4.4.2 Kitkat]
Firmware with Goclever quantum 700 [4.4.2 Kitkat]
Custom ROM explay [4.4.2 Kitkat]

CWM

CWM 6.0.2.8 (does not create backup)
CWM 6.0.3.3-old version (does not create a backup)
CWM 6.0.3.3 (creates backup)
CWM 6.0.2.7 (creates backup)

Instructions

Getting root rights from a PC
Getting root rights from the tablet
Instructions for firmware in PDF -Upgrade.pdf(386.68 KB)

miscellanea

Disassembling firmware
We remove the volume buttons from the nav bar (Only for 4.4.2)
We remove the volume buttons from the nav bar (Only for 4.2.2)

Screenshots

Screenshots from stock firmware
Screenshots from the ported kitkat firmware

Post has been editedMacintosh26 - 16.03.17, 23:29

Reason for editing: Mirror

[Macintosh26]

Route rights directly from the tablet can be obtained usingBaidu root

[Macintosh26]

CWMc Explay n1 plus

Posted on 07/25/2014 19:57:

Off-firmware screenshots

[Macintosh26]

Recently it turned out that n1plus and m1plus firmwares are suitable for it))
I also tried to install firmware 4.4 from a Chinese tablet, the tach module did not fit, I will soon try to change the modules

[serbeev.ser.]

I tried to root with baidu root, the tablet hung on a selection of methods, I also tried the older version, the root was not received, and the newer version I picked up the methods for half an hour and I turned it off. What program can I root this device?

[Macintosh26]

I have a great rut, you can even through kingo root via PC

[n7610rc5]

How does this firmware differ from explay favorite or are these clones?

[Macintosh26]

Clones, but in the favorite there is an item in the settings instructions and a list of modems and all

[Mr_Aspio]

Good day. During the last night I launch one program after another from the list offered on the forum, none of them gives results. Cannot open root access. Baidu Root works for five to ten minutes, until I cancel the task, because This is clearly a bust. Kingo root does not see the tablet through the PC. What could be the problem?

[-garaev-]

Mr_Aspio @ 09/04/2014 05:58

Baidu Root is working for five to ten minutes until I cancel the task.

Try the instructionsBaidu Root (Post # 33581916)

[Macintosh26]

For kingo, you need to enable debugging by adb

Post has been editedMacintosh26 - 31.12.14, 12:13

[Mr_Aspio]

Macintosh26 @ 09/04/2014, 11:49

For kingo, you need to enable otlarardu by yusb (adb)

Of course, it included, and a tick of not unknown sources was also.

[Macintosh26]

Did you install the adb driver?

[Macintosh26]

Firmware with irbis tx07
DownloadingFirmware
After installing the firmware, connect the tablet to the PC
Download the touchscreen patch and screenTyk!
Extract to drive C
Open screenshift.cmd
Enter 5
Then 6
Voila!


--------------
Note
The firmware android 4.2.2, but slightly modified, in the settings item is the calibration of the g sensor, etc.

Post has been editedMacintosh26 - 17.12.14, 17:22

[n7610rc5]

By the way, there is an error in the firmware of fog sounds, then there is no Russian, they put it in Medeo, but should be English.

[n7610rc5]

[email protected], 17:53

Firmware with irbis tx07

And you can do it on stock through rekoveri?

Post has been editedshoma_81 - 24.09.14, 22:55

Reason for editing: removed overclocking

[AjlekcaHgp MejlbHukoB]

n7610rc5 @ 09/21/2014, 02:53

...
And you can do it on stock through rekoveri?

I would collect, but I don’t really understand the principle of calibration of a wheelbarrow, and if it is calibrated in the system, then it is desirable to merge this block from it. If somewhere in sys, then I do not know the sales. Macintosh26, try to merge the system and check the theory, my mother hospital burned down, and the laptop should be taken from the small one.

[spassk14]

Macintosh26,Does everything work in the firmware from Irbis?

[Macintosh26]

[email protected], 14:24

Does everything work in the firmware from Irbis?

Everything works with the snow leopard, but msi needs to be redone a little, disassemble the boot and turn on the adb

[Macintosh26]

Worker 4.4.2, with a perfectly working touch
Download the firmwareDigma optima 7.6
Download the patchshp.rar(335.05 KB)


Extract to drive C
Open screenshift.cmd
Enter 5
Then 6
Voila!

Next, we get the root withKingo Android Root
DownloadingRoot explorer
Go to system / build.prop
We are looking for ro.sf.lcd_destiny = 160, change the value to 120

Post has been editedMacintosh26 - 31.01.15, 21:04

[Macintosh26]

Screenshots of firmware digma optima 7.8 with android 4.4.2 on board

Post has been editedMacintosh26 - 27.09.14, 18:32