Do your practice. Brought Sky T70 which is not included and immediately shook firmware for your advice. Not identify the ports and not sewn. He revealed the tablet - to BATTERY 4.2V and rokchip percent. 3a062 ***** I shook and flashed RKBatchTool in Upgrade mode. After the second restart crumbled Android application. I beg to Restore mode - everything is fine. (I advise the stitching mode)
Conclusion: 3a054 ***** for proca AllWiner
3a062 ***** for proca RockShip
3a075 ***** ?? neprobyval
By the way on what you are doing (3AIV043) Lot в„–: RP3AIV0430130901, which caused uncertainty.

Hello everyone. Brought the tablet hangs on the splash screen "roverpad". Then we do not ship.
I have to say about the release: on my copy is no volume buttons, although the instructions in the box to him she painted. Lot в„–RP3AIV0430130901. Serial number RP3AIV0430 ****. OS version 4.1.1 (which I found out after the restoration).
Firmware on the site was not found (not including the three where it is not known what kind of place), so I decided to clean up the service menu.
Calling up the service menu:

1. Press the reset button.
   
2. At once (it is important to almost the same time) we press the button "back" (I have it one except the power button).
   
3. When the light turns black screen (after a small androidika) button otpusaem.
   
4. After a few seconds will show the service menu.

If after a small androidika you lit the inscription "roverpad" the right time you miss, start from step в„–1.

So I cleaned:

• wipe data / factory reset
  
• wipe cache partition

All tablet as good as new.
P.S. If I knew how to merge firmware would be merged without fail.

Post has been editedyan.ab - 18.12.14, 20:53

So, finally I managed to get a Root for our tablet. My tablet is based on AllWinner A20 processor. How do you get Root?
1. Go toRecovery . Since we do not have the volume buttons, the developer made a separate item in the setup menu for us. Go to the settings, click on the Backup & reset>Recovery Mode.
Note that the Recovery control sensor. Swap up and down - this menu control, tap - to accept.
2. It is necessary to completely clean your Tablet PC. To do this:
- wipe cache partition . The tablet will reboot and Again you need to go into recovery .
- wipe data / factory reset . Fully cleanse tablet
- Reboot system now . Reload.
3. Connect your tablet to your computer (or download the file directly) and toss that file to the root folder:
root.zip(576.86 KB)

4. Again we go inRecovery and click on the button apply update from external storage . Select the file Root.zip. After unpacking the file, restart your tablet using Reboot system now and use;).
5. If desired, update SuperSU, since this is a bit old.

I have too much to do the procedure on your tablet. I use third-party programs, such as Kingo Root, Ding Dong Root, UNLOCK ROOT PRO, but they only set SuperSU program and gave an incomplete Ruth. Applications and so could not ask for Root access. After I tried to install the custom CWM, for it is not found in the Recovery tablet. And now, after 2-3 days of torment, it has RoverPad Root;)

Post has been editedEnlightened grandfather - 03.01.16, 15:08

Maybe the question is not subject? how to install the driver for this model. Trying to flash it run Phoenix click Start and then return quickly connect the cable and On button many times. Phoenix stops responding and dies when I disconnect the tablet.

Download the firmware of-and in this archive is complete driver and guide

Posted on 10/01/2015, 16:53:

People tell me what alternative firmware can be put on it?
I have a tablet with Rock chip set ROVERPAD SKY T70 3AIV043 RP3A062 as described above, but the firmware flies after tablet reboot if there are any options?

downloaded did everything according to instructions, the device undetectable. How do you determine what percent do you?
I understood like, looked at keygen

Post has been editedkeeperd - 10.01.15, 17:00

In I have the same, it is better not to put off with. site. Also will fly?

set how time has rebooted, not flies.

Post has been editedkeeperd - 10.01.15, 18:07

I hoped that in the firmware will androyd 4.2.2, as stated in the sale, but alas 4.1.1, ling

<sub>In I have the same, it is better not to put off with. site. Also will fly?

set how time has rebooted, not flies.</sub>

3 times already sewn, 1 and 2nd after the first reboot flew 3 times already, one was still working
I tried to sew restore and update

Regarding the charge level jumps. I replace the battery with a new one - all remained as before, the level jump from 80 to 20, and then for a minute "charge" on 80, and so constantly. Flashing can affect or is it, as I think, a hardware problem?

The same trouble with the charge discontinuously, a current of 20 to 60% jumping. Batteries suffice maximum for an hour in the game, during the discharge leap in the opposite direction from 60 to 20. Probably buggy charge controller.

Thank you for Ruth works !!!


Post has been editedEnlightened grandfather - 28.01.15, 04:23

There is a problem: use the tablet for telemetry (racing game), via Wi-Fi, it should simply supported on the back of the monitor. And recently begun this telemetry is very slow. It turned out very hot where the antenna. Somebody faced with?
And even remove the back cover?

Cover anything subchain thin on the perimeter, better plastic, such as a mediator, and pulled away, she keeps on mounting. I, too, basking in active use, but do not notice the lag.

So one never found Sew 4.4?

I welcome you to the kids, do not tell me a way to return the sound of an external speaker, who disappeared after the firmware. On the first page is already flashed this problem, but the description of the solution was, thank you in advance.

I found saytik with firmware from the rock chip I think if you dig something we choose for our animal
http: //www.rockchipfir...com/firmware-downloads

And I will share their experiences firmware. Allwinner processor. Scheele through Phoenix on vin7 x64.
3a054 set twice, both times there was a problem with the screen - touch inverted, as if divided in half vertically.
3a075 approached. Later, I will write about the behavior of the battery after flashing.

Please tell the combination of the Reset tablet

infy_bard, which combination is via rekaveri! or tablet reset settings