hi friends help out the phone, I stopped seeing SIM cards, any of them! in the settings about the phone there is no communication module (firmware of the communication module is unknown)

ari1,
I dug you stock backup firmware!
HERE YOU CAN DOWNLOAD IT:
FIRMWARE
According to the translation, it is suitable only for H9008 +
Also, when flashing, IMEI flies
For firmware you need SP Flashtool
Shy withhttp://www.needrom.com/download/h9008-stock-rom/

Post has been editedEnlightened grandfather - 05.11.14, 09:36

THANK!!!!!!!

Thank you, dear man! for help!

I got this phone myself. I saw it had problems with spontaneous shutdown. How can this problem be solved? And will the service center help? Or is it a marriage?

It seems like nothing. Using only one SIM card reduces the frequency of shutdowns, but is not treated at all. I already changed the phone - got tired.

I don’t know how you test the batteries, but when fully charged, the Battery Monitor Widget prog shows how not surprising but 3000mAh. I may doubt it myself, but it shows the program.

Simply. Current * time. Charging at a known current for how long.


I have a flash drive that shows a volume of 34GB on any system. Actually, 128 MB is only included.

I propose to check the current itself rises to 4.3v.
Half-discharged battery shows 1500 mAh fully 3000mAh
But I had a problem with the power controller covered,
the service said that they changed at the same, although the phone began to charge longer.

Current in amperes (A) is measured. In volts (V) voltage is measured.


It is not possible to "show" the battery charge in mAh. You can measure the voltage at the contacts. Knowing the remaining characteristics and calibration results, you can calculate how many percent is left.

The easiest option is to put an ammeter in the charge circuit. If a current of 1A flows during charging and charging takes 3 hours, then 1 * 3 = 3Ah or 3000mAh.
This phone is charged with a current of 500mA in 3 hours, which means its capacity is 1500mAh. This is without taking into account losses and a decrease in current at the end of charging.
Here I somewhere posted pictures and results of measurements. Measured with an ordinary ammeter, then checked with such a little thing.

I don’t want to prove anything, I’m not strong at that,
I have common concepts. I don’t confuse anything with volts and amperes 4.2v-100% 3.6v-15% of the battery charge.
I propose to install from the market and see for yourself if it's interesting.
And as far as I know, this device in the photo shows the bandwidth of only charging, in A

Post has been editeds.a.f.82 - 14.12.14, 01:51

s.a.f.82, the meter measures both current and voltage

I installed the program. Everywhere we are talking about voltage, i.e. about stress. There is nothing about the current

Well, maybe there is mAh on the screen

Post has been editeds.a.f.82 - 15.12.14, 01:54

I took the battery itself from vowney v5. Fits perfectly

For owners of THL H9008 + (Tian-Hi H9008), you can use a can of Samsung Galaxy Note 2 N7100 (2500 mAh) to remake the battery. When removing the sticker, the inscription CP555571AR HV (UHV - even cooler - 3100mAh) is found.
We release the jar from the plastic strips from above and below: Carefully and not deeply cut the joints between the jar and the strips. Carefully on top (where the controller is) so as not to short-circuit the jar! At the top from the end from the side of the Contacts, swing the connection with a scalpel. Next, shaking the planks relative to the banks, separate them. Tape conductors without breaking - have a bite. Otherwise, aluminum will have to be soldered.
Next, solder the controller with two wires (on the plus case, on the controller it is on the contact side). We insert the controller into the frame (contacts in place) and fill the openings between the frame and the bank. Instead of a sticker, I used adhesive tape.
The only minus of the alteration is the thickness of the non-native battery is a millimeter larger. When closing the back cover, the middle of the phone’s touchscreen may protrude. It does not affect work and is not critical in a book-case. : yes2:

The second battery is even better. The can was taken from Noute 3 - it is thinner and narrower, but longer by a couple of millimeters, 3100 mAh is written in the characteristics. Subjectively, the capacities of the previous and the same are the same. I think it is determined by the controller. The difference in weight is 54 and 48 grams. The difference in the alteration - I had to remove the lower crossbar of the native frame. The battery is longer than the original. Comes in tight. But the thickness of the original is several dozen with adhesive tape and there is no protrusion of the touchscreen! : P