[X]Assistant

[ctich]

Huawei HG8245- Discussion

Description

Echo Life HG8245(and its submodels: H, T, etc.) is an internal network optical terminal (ONT) in the Huawei FTTH solution, which serves as a multifunctional home network gateway. Using GPON technology provides ultra-wideband access for home users and small offices (SOHO). The HG8245 provides two POTS ports, four GE / FE autonegotiation Ethernet ports, and one Wi Fi port, and features high-performance routing capabilities to provide enhanced VoIP, Internet and HD video services.

Opportunities

• Port: 2POTS + 4GE + 1USB + WiFi.
  
• Plug-and-play (PnP): Internet, IPTV and VoIP services can be implemented in one click on the NMS and do not require local configuration.
  
• Remote diagnostics: Remote fault localization is implemented by testing POTS ports on a line loop and simulating calls and dial-up connections initiated by the NMS.
  
• High-Speed ​​Routing: Routing at the GE line speed in a bridge connection scenario and at 900 Mbps in a NAT script.
  
• Eco-friendly energy saving technology: Energy savings are 25% using a highly integrated chipset based system (SOC) solution, in which one chip is integrated with PON, voice, gateway and LSW modules.

Firmware

HG8245

• HG8240 V100R003C00SPC106_BMS
  
• HG8245 ONTV100R003C01SPC108
  
• HG8245 ONTV100R003C00SPC108
  
• HG8245 V1R006C01S122
  
• еЌЋдёє 8245E8-C sjt-C00SPC205
  
• HG8245V100R006C00SPC130_full
  

HG8245H

• HG8245H V300R015C10SPC130
  
• HG8245H V300R013C10SPC122
  
• HG8245H V300R013C10SPC118
  
• ONTV300R013C10SPC940T_common_debug
  
• Firmware for HG8245H (common_all)
  
• HG8245HV300R015C10SPC155

HG8245T

• HG8245T V200R006C00SPC201
  
• Firmware for HG8245T from 06/16/2016
  
• HG8245T V200R006C00SPC202

useful links

• Configuring WI-FI on the optical terminal HUAWEI 8245
  
• How easy it is to change the superuser password (telecomadmin) to Huawei HG8245
  
• Connecting USB flash drive to Huawei HG8245
  
• Opening port on HG8245
  
• How to change password on Huawei HG8245
  
• EchoLife HG8240 / HG8245 / HG8247 GPON Terminal Service Manual
  
• Change superuser password (telecomadmin), still
  Options for standard login / password combinations to the full web interface

  telecomadmin \ admintelecom
  telecomadmin \ NWTF5x% RaK8mVbD
  telecomadmin \ NWTF5x%
  telecomadmin \ nE7jA% 5m
  telecomadmin \ xyz
  admin \ * 6P0N4dm1nP4SS *
  telecomadmin \ s2Mu5LrUYXvoRGxWT0By8D1QCmOpdKgAqjIcE7i6w94VtzJnbHpost TRAF666
  superadmin \ haPie9goHf -Post kalibulax
  If passwords are not suitable, a full reset may help.
  MGTS uses the standard admintelecom password. If this password does not fit, you can call those. support (495) 636-0-636 and say that you cannot log in as administrator (more).
  
  
  
• How does one change Huawei to another?
  

There is no curator in the subject. If there is a user in the subject who wants to become a Curator and the correspondingRequirements for candidates, he can apply in the topicI want to be curator(after having studied the topic header and all materials for curators). Prior to the appointment of a curator for filling caps, please contactmoderatorssection through a buttonunder the messages to which you want to add links.

Post has been editedAndrewP_1 - 02.02.19, 11:19

Reason for editing: How one Huawei change to another

[Myf]

I did not find anything suitable here. Therefore, I decided to create a separate topic.

Plugged inRosteles on optics Internet + TV + wired telephone.
All this is connected via GPON terminalHuawei HG8245
There is no normal description. Even on the Huawey site, only vague administration instructions. All that was found:
- 4 xGbit ethernet
- Wi-Fi N(judging by the two antennas, probably 300 Mbit)
- 1 x USB (it seems that only for FTP server)

Now about miracles ...
1. ByEthernetconnects only to 100 Mbit / s, although the computer actually worked with other equipment at Gigabit speed.
2. Wi-Fi speed - on lamer sites, the favorite topic of defacing is about speed instability ... and"The actual speed differs from that shown in the connection properties ..."All this we have heard a million times.
There are two computers withWi-Fi N. One is exactly up to 150 Mbit, the other is not true, maybe up to 300 Mbit. And furtherSony Xperia Z (C6603). All of them show in properties of connection with the terminal 65 Mbit. And, judging by the tests, this is the real speed, because Internet speed rests only on Wi-Fi. On the wire, the results are higher. And this speed does not depend on the choice of the channel or the distance to the terminal - always 65 Mbit. I tried to select "Channel Width = Auto 20/40 MHz" in the ONT settings (it was "... = 20 MHz") - it did not help.
And they all connect withD-Link DIR-300at 150 Mbit. But the real test speed is again around the same 65 Mbit.
That's what I still do not understand:
2.1 If the speed in all cases 65, then why D-Link shows 150?
2.2 Why can not really connect to 150?

[bio0]

MYF @ 03/21/2014, 10:59 PM

Now about miracles ...
1. Ethernet connects only to 100 Mbit / s, although the computer actually worked with other equipment at Gigabit speed.
2. Wi-Fi speed - on lamer sites, the favorite topic of splitting is about instability of speeds ... and "the real speed differs from the one shown in the connection properties ..."
There are two computers with Wi-Fi N. One is exactly up to 150 Mbit, the other is not true, maybe up to 300 Mbit. And more Sony Xperia Z (C6603). All of them show in properties of connection with the terminal 65 Mbit. And, judging by the tests, this is the real speed, because Internet speed rests only on Wi-Fi. On the wire, the results are higher. And this speed does not depend on the choice of the channel or the distance to the terminal - always 65 Mbit. I tried to select "Channel Width = Auto 20/40 MHz" in the ONT settings (it was "... = 20 MHz") - it did not help.
And they all connect to the D-Link DIR-300 at 150 Mbit. But the real test speed is again around the same 65 Mbit.
That's what I still do not understand:
2.1 If the speed in all cases 65, then why D-Link shows 150?
2.2 Why can not really connect to 150?

Miracles are absolutely the same. There is a WiFi speed limit through this terminal, when connected to it via the patchcord, the speed is given out. I did not find a solution, the operator Rostelecom referred to the limitation of WiFi technology (and what else to expect?)

[Mealsul]

Does anyone know how to configure FTP on it? It is desirable with pictures, and then aglitsky is lame ...

[Erne1000]

In order to configure access to a USB flash drive via FTP through the Huawei HG8245 optical terminal,

You need to connect the USB flash drive to the USB-connector (maximum 32GB) and go to the web interface of the router.
The IP address of the device on the network is 192.168.100.1,
Terminal Web Interface URL -http://192.168.100.1,login access: root, password - admin
(if not suitable - try login: telecomadmin and password: admintelecom).

First of all, it is necessary in the section "Security" =>"ONT Access Control Configuration" check "Enable the LAN-side PC to access ONT though FTP":

Click Apply and then go to the menu section "Network Application" =>"USB Application"

Here we put a tick "Enable FTP Server". Below will be available to edit the settings of the FTP server:

In the "User Name" and "Password" fields, you must enter an arbitrary username and password to access the FTP server.

It is desirable, of course, that the login is different from the optical modem used to access the web interface.

Below, in the "Device" field, select the connected USB flash drive.

In the field "Root Directory Path" you must enter the path to the root directory of the flash drive.

You can change the contents of this field only if you need to restrict access to only one folder on the USB-drive.

Click the "Apply" button. We try to log in using an FTP client, or click on the link:ftp://192.168.100.1

[gilait]

Is there a speed distribution for mac or ip in this router or something like that?

[bered321]

Has anyone been able to share the first 3 ports under the Internet with this router, the latter under the telly? Doing a collective farm of two routers to extend the wired lan is not very desirable.

[lisa1966]

Here are the settingshttp://nastroisam.ru/hg8240-hg8245/

[evgenos99]

In order to change something serious it is necessary to log in as a superuser, Rostelecom has closed something serious for change. To log in as root you need to know the corresponding password. Its Rostelecom constantly changes, but it can be found in the configuration file of the router. How to do it there is a corresponding instruction

Posted on 10/29/2014, 20:51:

Someone can describe how to connect to the 8245 dlink router via cable, so that dlink distributed the internet via wifi

[Darknorth]

To log in as root you need to know the corresponding password. Its Rostelecom constantly changes, but it can be found in the configuration file of the router. How to do it there is a corresponding instruction

But where can I look for instructions?
thank.

[evgenos99]

DarkNorth,
For example, herehttp://forum29.ru/showthread.php?t=39504&page=72

[vepery]

People, that's the thing, I have 300 meters of speed and wifi gives only 10 meters where can I set the speed of wifi in the settings? ;)

[evgenos99]

vepery
Who distributes wifi

[vepery]

evgenos99,

I do not understand you .... who distributes? : Happy: I have a modem in the apartment, on all devices, well, the phone and tablet everywhere measured the speed of exactly 10 meters, and on the wire to the stationary computer 300mb / s, I ask where the modem transfer rate is set to wifi and maybe it can also be 300 mb / s?
Rostelecom 1000r per month and 300 m / s, on optics


Post has been editedvepery - 03.11.14, 22:34

[Shoore]

Vepery @ 11/03/2014, 10:32

can it be 300 mb / s too?

https://ru.wikipedia.org/wiki/IEEE_802.11n

[vepery]

Shoore,Theoretically, 802.11n is capable of providing data rates of up to 600 Mbit / s gross, applying data transfer over four antennas at once. On one antenna - up to 150 Mbit / s. ;) I would at least 150 squeeze out of it: D

[Shoore]

Vepery @ 11/04/2014, 00:18

Theoretically 802.11n capable

Well, if there is one on both sides of WiFi traffic, then you need to turn on and try to reap: D

Posted 04/04/2014, 00:56:

And in general, as it seems to me, the topic just started with this claim, didn't it?

[evgenos99]

vepery
Wifi from huawei hg8245? If yes, then it cuts the speed of wifi very much. I also couldn’t do anything with it - I tried various settings, but it’s all useless. Apparently crooked equipment or firmware Rostelecom. I did this - connect dlink dir 825 with ddwrt firmware to it. Now at a rate of 100 wifi gives 70-80.

Post has been editedevgenos99 - 04.11.14, 22:42

[freezza]

Hello, tell me how to connect 2 computers to the Internet through a cable through this router, it is not banned in Google))) but I could not find the answer to this question ...........
Please do not kick much: blush:

[freezza]

everything worked out

Password = "admintelecom" UserName = "telecomadmin": D

the question is removed

Post has been editedfreezza - 06.11.14, 21:46

[lalkaaa]

Guys, with which there may be a problem, disconnected the modem from the network, turned it on and after switching on, the modem turns on, the required indicators light up, and literally passes 5-7 seconds after turning on, it reboots and so every time, as a result, it probably does not connect until the end, and it reboots and nothing works, what could be the problem?