Firmware tablet using RKAndroidTool
1. Requirements: - File RKAndroidTool firmware Cube U30GT2
Personal computer or laptop / netbook running the Windows operating system
USB cable (
We use a good cable to connect, but not the one that comes)
2. Initial Setup Extract the downloaded firmware folder
The path to the folders with the program and firmware should not contain Russian (Chinese) letters and spaces. Run RKAndroidTool (hereinafter RKATool)
menu RKATool Buttons 1. initialization of the setup of the selected files to the plate
2. Cleaning stories firmware
3. initialize low-level NAND flash memory format
4. Tablet translated from the "debugging on USB" in flashing mode
5. select the file pointer to the firmware
6 Address mixing NAND memory (registers in accordance with the parameter file)
7 file name
8. The arrangement of the installed file
9. Review button (search) file location
10. version RK3188Loader
Additional functions Additional functions appear when you right-click in the software field
Add Item: adds a row in a field
Del Item: deletes the selected row
Clear Item: remove all lines except the first
Move Up and Move Down: moving up / down the selected stitch
Import configuration saving configuration program
Export Configuration: restore configuration
3. Installing device drivers How to install the driver read
hereor
here4. Install new firmware So, the driver is installed, and now we can upload new firmware to the device.
Firmware with RKATool different from Rockchip Batch Tool.
Differences that RockChip Batch Tool is used to flash the firmware version of the full, and RKATool enables flashing, only the selected part of the firmware (kernel, boot, recovery, etc.).
We strongly recommend using a program that is part of the firmware and run from the directory formed after unpacking the archive with the firmware. RKATool needs a configuration file, which is given together with the firmware.
DO NOT CHANGE these settings, otherwise you can get a brick!
Do not play with offset values. Just kill the device.There are two ways to enter a tablet in flashing mode: simple (by this program) and complex (push button).
1. Use RKATool:
a) Turn on the tablet to stick to it and connect the USB cable to the PC. The tablet should be included "Debugging USB"
b) Run the ROM Flash Tool. The bottom line should appear
«Found RKAndroid MASS Storage USB» c) Press «Reboot to Flash Mode». After a few seconds, the device will reboot.
d) If the drivers have been installed correctly, the tablet screen turns black, and the program should now appear at the bottom
«Found RKAndroid Loader Rock USB» Go to step 3.
2. Using the buttons: a) Turn off the tablet
b) Press and hold the volume up button
c) Without releasing the volume button, press and hold the Power.
d) After 5 seconds, the computer will inform about the connected device.
e) If the drivers have been installed correctly, is now in the program should appear at the bottom
«Found RKAndroid Loader Rock USB» Go to step 3.
3. The need to clean the internal memory prior to insertion. press
Erase NAND (IDB) In the info window should appear «Doing Lower Level Format, Total (*****)» (
the number of asterisks specified at all different)
IMPORTANT! Current in the line have to report numbers to *****, and the operation is completed.
If the numbers are not counted (sometimes), restart RKATool and click Erase again.
If the numbers do not run anyway, close the program, reboot the tablet into firmware mode again and try again.
4. It's time to be sewn. press
«Flash ROM» And let the program do its job.
The operation will take several minutes. Upon completion, the tablet will reboot itself.
FIRST DOWNLOAD! If everything went without problems, the tablet will automatically turn on and enter the rekaveri. After that will automatically format the cache, data partitions, etc.
After formatting and installing the firmware, the tablet will reboot and the installation of the firmware inside the tablet will begin
The first boot will take longer than usual.
Post has been editedalexomsk66 - 14.02.14, 14:35