TP-Link TL-WR740N - Discussion | [wifirouter] Discussion, firmware, problem solving



Rep: (1967)
TP-Link TL-WR740N- Discussion

Attached Image

The forum decided to post images under the spoiler Attached Image

A photo:
Attached ImageAttached Image

Description:
TL-WR740N - is a combined wired / wireless network device that provides shared Internet access and combines the functions of a router and 4-port switch. This router uses 802.11n technology and is compatible with all devices that support 802.11b and 802.11g standards. It provides data rates up to 150 Mbit / s, which is significantly higher than the rate on the basis of 11g devices, and allows you to enjoy applications such as watching a video, IP-telephony and online games anywhere in your home or office. Experience all the benefits of 11n technology with TP-LINK wireless devices!
Provides data transfer rates up to 150 Mbps
CCA technology improves wireless network performance by automatically preventing channel conflicts
WDS support for expanding your network
One-touch QSS quick setup
The priority function ensures the quality of sensitive applications such as video viewing and calls over the network
SPI firewall support and access control features
WPA / WPA2 encryption support
Full compatibility with devices that support the standards 802.11b / g / n

Specifications:
Hardware
Ports 4 10/100 Mbps LAN port
1 10/100 Mbps WAN port
Buttons Quick Protection Setting Button (QSS)
Reset button
External power supply 9V DC. current / 0,6A
Standards of wireless data transmission IEEE 802.11n *, IEEE 802.11g, IEEE 802.11b
5dBi antenna fixed omnidirectional antenna
Size (W x L x H) 174 x 118 x 33 mm
Parameters of the wireless module
The frequency range of 2.4-2.4835 GHz
11n signaling speed: up to 150 Mbps (dynamic)
11g: up to 54 Mbps (dynamic)
11b: up to 11 Mbps (dynamic)
EIRP (Wireless Power)<20dBm (EIRP)
Sensitivity (reception) 130M: -68 dBm with 10% PER
108M: -68 dBm with 10% PER
54M: -68 dBm with 10% PER
11M: -85 dBm at 8% PER
6M: -88 dBm with 10% PER
1M: -90 dBm at 8% PER
Wireless functions Enable / Disable broadcast, WDS bridge, WMM, Statistics
Wireless protection 64/128/152-bit WEP / WPA / WPA2, WPA-PSK / WPA2-PSK
Software features
WAN connection type Dynamic IP / Static IP / PPPoE / PPTP (dual access) / L2TP (dual access) / BigPond
DHCP Server, Client, DHCP Client List, Address Reservation
QoS (Quality of Service) WMM, Bandwidth Control
Port Forwarding Virtual Server, Port Launch, UPnP, DMZ
Dynamic DNS DynDns, Comexe, NO-IP
VPN pass-through PPTP, L2TP, IPSec (ESP Head)
Access Control Parental Control, Local Control, Host List, Access Schedule, Rules Management
Network security (firewall) DoS, SPI firewall
Filtering by IP Addresses Filtering by MAC Addresses Domain Filter
Binding IP and MAC addresses
Management Access Control
Office in place
Remote control
Other
Certificates CE, FCC, RoHS
Scope of Delivery TL-WR740N
1 fixed omnidirectional antenna
Power Supply
Information disc
Quick Installation Guide
System Requirements MicrosoftВ® WindowsВ® 98SE, NT, 2000, XP, Vista в„ў or Windows 7, MACВ® OS, NetWareВ®, UNIXВ® or Linux.
Environmental Parameters Operating Temperature: 0 ℃ ~ 40 ℃ (32 ~ 104 ℉)
Storage temperature: -40 ℃ ~ 70 ℃ (-40 ℉ ~ 158 ℉)
Humidity (operating mode): 10% ~ 90% non-condensing
Humidity (during storage): 5% ~ 90% non-condensing
Firmware
Useful:

Topic Curator: Topic with no curator


Post has been editedninja88 - 11.04.20, 10:13
Reason for editing: Adding USB-port, increase memory, and a USB flash drive 64/8 (TL-WR740N V5)



Rep: (11)
Tell me the solution to the problem.
It was a router from D-Link, has been losing a connection, I thought it deal changed at TL WR740N, the problem persists.
Became sin to the provider (residents near Moscow know what Telinkom), but it was not in it, because lost to communicate directly with the router.
The level of signal may be the maximum, but even 192.168.0.1 will not open.
Tried to hang on the free WiFi channel and gertsovku changed, nothing helps.
The problem occurs on multiple devices (of course at a time).
It helps only restart the router.
The firmware version on the screen.

Attached images
Attached Image



Rep: (424)
AI_11 @ 02.06.19, 22:07*
I changed at TL WR740N, the problem persists.

Seek Chinese - it has a problem.



Rep: (11)
* Herzz,
DD-Wrt try in the sense?



Rep: (77)
* AI_11, No device as Chinese fi-Fi module, itfoul upclutter so air as the rest plaguing not.

the easiest way - to change the name \ password of the access point and plug the device gradually. once to connect the next "START" - congratulations, you have found the Chinese shpienov :)



Rep: (11)
* Eternox,
It appeared more to the point when the two were connected iPhone and one aypad.
Now the "network life" involved iPhone, Honor and two aypad.
In all of these devices, as far as I know, good modems.
Although the relationship I have observed, when you connect some device loses connection to iPads, this certainly was.



Rep: (0)
Eternox @ 02.06.19, 20:39*
SSH to help, but then on vyshezadannye answer questions themselves should know

Measure twice, once ... Briquenay: D With guem certainly nicer buttons zhmakat. Found at the docks a detailed manual for the assembly of an economical way without IPv6 and with minimal luci (what it is minimal - not found). Recommend doing so for all devices with a 4MB, but the miser to establish an assembly of at home. I think before the amateur should attend custom boot loader, to save on the pain in the ass in the future?



Rep: (186)
Sashakashvile @ 03.06.19, 16:02*
I think before the amateur should take care of custom loader

TP-Link TL-WR740N - Discussion (Post butaford # 73337595)



Rep: (10)
How to configure ddwrt Googley dns, running in repeater mode, the dhcp dns with prescribed cut down, after the repeater settings.



Rep: (77)
* ivanovs Repeater = repeater. Here the signal is picked up - go there. All.
All settings, including Google-dns made on the main unit.



Rep: (10)
Eternox @ 05.06.19, 14:32*
= repeater repeater. Here the signal is picked up - go there. All.
All settings, including Google-dns made on the main unit.

Basic, neighborhood: D then go to openwrt there are no problems such as this shit ddwrt-shnom.



Rep: (77)
* ivanovs, and neighbor-I suppose it is still in stock: rofl:



Rep: (0)
Prompt router constantly cutting speeds of up to 10Mb of 100, makes it a reboot and after a while again cutting

Post has been editedartkahn - 05.06.19, 17:15



Rep: (13)
* artkahn , Check the network cable as an option



Rep: (38)
itbrazers @ 05.04.17, 23:41*
Then add to the startup frequency of the launch to choose right now, I Connected: 3d 22h 29m 13s to run the script and it was more than a week and Uptime 18d 22h 39m 7s

itbrazers @ 05.04.17, 23:41*
Then add to the startup frequency of the launch to choose right now, I Connected: 3d 22h 29m 13s to run the script and it was more than a week and Uptime 18d 22h 39m 7s


tell me what kind of script where it add and why. It is through the web or face putty? how to do it



Rep: (45)
And what is the maximum real speed Wi-Fi at this devayse (TL-WR740N v4), with a good signal (up to 5 meters to a point in the line of sight)? And then my DD-WRT is now the last 35 Mbps Download / Upload 39 Mbps of Wi-Fi, via cable all clearly (92-98 Mbps).

I think the drain before to 70 Mbps reached on Wi-Fi, is not it?



Rep: (424)
Dreyk007 @ 07.06.19, 21:19*
Wi-Fi real speed

70/98



Rep: (45)
Herzz @ 7.06.19, 21:53*
70/98
MDE ... The time will come, I will try to drain flash and see what happens. And what version LEDE / OpenWRT or DD-WRT most stable for our devices? The latter, as I understand it, is not very ...



Rep: (424)
Dreyk007 @ 07.06.19, 21:59*
There will be time, I will try to drain flash and see what happens.

Yeah ... and change devays on the laptop with the new WiFi unit - just help)



Rep: (10)
Dreyk007 @ 08.06.19, 00:19*
And what is the maximum real speed Wi-Fi at this devayse (TL-WR740N v4), with a good signal (up to 5 meters to a point in the line of sight)? And then my DD-WRT is now the last 35 Mbps Download / Upload 39 Mbps of Wi-Fi, via cable all clearly (92-98 Mbps).

I think the drain before to 70 Mbps reached on Wi-Fi, is not it?

Shay drain or openwrt, ddwrt shit.



Rep: (45)
ivanovs @ 8.06.19, 6:42*
Shay drain or openwrt, ddwrt shit.
and planning. Only need to remember how to properly collect openwrt minimalist) somewhere I even had a build-config for this device. I do not remember why I dd-wrt eventually stopped (in 2016 her works, and here decided to check the speed and ofigel, then updated the dd-wrt and again ofigel), probably just too lazy to openwrt collect, and in the ready builds on the time that did not suit.

Tell me, what advantages will the modified bootloader? Just ease recovery from okirpichivanii?


Full version    

Help     rules

Time is now: 05/01/20, 12:07