Attention! After recovery, the firmware ColorOS dated July 13, 2012 and standard recovery will be installed. Data will not be saved! Make a backup.1. Download
archive.It consists of: programs (+ necessary files), drivers and instructions (in English).
2. Unpack.
3. We transfer the computer to the test mode. To do this, open the command prompt as an administrator and enter:
bcdedit / set testsigning on
4. Restart the computer. After that, the corresponding message should appear on the desktop (in the lower right corner). (Test mode, Windows version and build number).
5. Open the program "Download_Development" on behalf of the administrator, select "SelectAll" and click "Start Download".
6. Next, you need to turn off the phone (if it is rebuilt, try holding the power button longer). Hold down the volume up button and connect the phone to the computer. Now you can release the button.
7. Open the "Device Manager", in the "Ports (COM and LPT)" section, the phone should appear as "Qualcomm HS-USB QDLoader 9008".
8. Right-click on "Qualcomm HS-USB QDLoader 9008" and select "update driver", "Run a search on the computer" and select the folder where you unpacked the archive with the drivers.
9. After installing the drivers, the “Qualcomm HS-USB QDLoader 9008” port will change its name to “Qualcomm HS-USB Diagnostics 9006" and the download will start in the program (this can be seen from the appeared status line in the 9th paragraph).
10. In a few minutes the 9th item will be highlighted in green (the download line will disappear). This means that the phone is restored. You can turn it on by holding the power button for about 10 seconds.
11. Congratulations, the phone is restored. Installed ColorOS firmware from 07/13/12 and standard recovery.
Thanks for the instructions
Yurez 234.