We have a file system
EXT4 . Therefore, we are skipping everything about yaffs.
1. Making scatter with MTKDroidTools Scatter is a text file with block addresses needed for SP FlashTool.
Download CWM
CWM-Based Recovery v6.0.1.2 (compiled by Bruno Martins)Better download in advance. It will come in handy in paragraph 7.
2. In FlashTool select this scatter and go to the Read Back tab 3. Select the path and file name ROM_ 4. Set the size of ROM_ Type must be in HEX.
In the Start Address field, write 0x000000.
In the Length field, copy from scatter
cache block address .
Hex numbers must begin with
0x 5. Select Read Page Only on phones with yaffs2 blocks. On phones with EXT4 blocks, this
not selected . (skip this point)
6. Read ROM_ We take out the battery.
We press the Read Back button and we connect the switched-off body without battery to the PC.
After a few seconds, the download will begin.
We are waiting for 20-30 minutes until it ends.
7. Prepare files for FlashTool and make CWM If everything went without errors, then open the MTK Droid Root & Tools window, which we left in 1 point. If for some reason there is no window, then you need to turn on the phone and connect it to the program. In the program, on the root, backup, recovery tab, click the Create backup from ROM flash button and select the ROM_ * file saved in point 6. The block building process for FlashTool begins. Remember the name of the folder. Upon successful unpacking of boot, a patched boot will be created and you will be prompted to select a file
CWM which downloaded in paragraph 1 . The selected CWM is checked for compliance with the connected phone, and if ok, a new CWM file is created.
8. Flashing CWM to the phone We launch FlashTool, select scatter in the folder created in paragraph 7.
Remove jackdaws from all blocks!
We click on RECOVERY and select the CWM file in the same folder that was created in point 7. It will exhibit a daw.
We make sure that the daw is only on mod.rekveri and click
Download , connect the cable to the PC and wait for the end of the process.
In no case do we use Firmware Upgrade instead of Download at this step! 9. Make a backup, install SuperUser etc We load the body into CWM mode, connect and connect to the MTK Droid Root & Tools, go to the root, backup, recovery tab and, clicking on the buttons on this tab, do:
- Backup !!! Mandatory !!! (takes about 20 minutes)
- install SuperUser (often mean "Get root (get root)" under this)
- delete Chinese programs
- set the default Russian language and time zone Moscow
Patched boot does not need to be flashed.
In paragraph 9, the computer may not detect the phone loaded in CWM and will ask for a new driver. If this happens, download the latest drivers:
ADB_usb_driver_120827_v3.7zPost has been editedAndreyA100 - 07.03.13, 09:13