I live in a private house, I use a USB modem and I want Wi-fi throughout the house, but I learned that with a router the signal is very weak and I need an amplifier to restore this signal. Tell me, is it true and, if so, what is better to do in this case? Thank.

Why? Or is the signal weakening, WiFi?
Depends on the router and the size of your home. In most cases, the signal power is enough to cover the house.
It is better to purchase a router with two external antennas, for example, Kenetic.
What devices need to be connected to the Internet, what is the distance from the intended location of the modem and router to the devices?

Post has been editedJustmoose - 15.02.14, 21:15

The WiFi signal weakens.
I want to connect the tablet and netbook, well, about a distance of about 5-7 meters ..

Any router will cover this distance (of course, if it’s not 5-7 meters of reinforced concrete :-))

Post has been editedJustmoose - 28.10.12, 17:51

Keenetic 4G modem
Software V1.00 (AABV.1.2) D0 May 30, 2012 00:15
Win7 Ultimate WiMax 5051 Wi-Fi Module
Problem:
I'm trying to distribute the Internet (YOTA modem LU150) over WiFi. Connection to the access point occurs, but the Internet is not distributed.
In the network management center writes that "Restricted Access."
A YOTA modem connected directly to the computer is connected normally. When connected via an ezernet cable (to adjust the kinekta), the Internet works fine.
What could be the reason for restricting access? I enter the password correctly, the settings are suitable.

Thanks for attention)

I can't create an access point

TP-LINK TL-MR3020
Hardware version of the device: v1
Firmware Version: V1.00_120817
Your country: Russia
Provider Name: MTC
Connection Type: Dynamic IP
Rate: 3 Mbit / s
Connect from PC via wifi or cable ?: via cable
Your operating system: Windows XP
Antivirus software and firewalls: DrWEB
1 connection option switch to 3G, modem to router, network cable to comp. Everything works, WiFi is distributed, the computer goes to the Internet. But the speed is 2 times lower and frequent falling asleep and plugging, compared to when a 3G modem is plugged into the computer directly.
Therefore, I want to implement the following connection scheme:
1.3G modem on a straight line in a computer.
2. I connect the router with the computer.
3. Switch to AP.

In such a scheme, the Internet works well for me through a computer (which is very natural),
but the Internet is not distributed over WiFi. (other devices see WiFi, but cannot get an ip address)
In Wxp in network connections in "Local Area Connection" - it says "Connection is limited or absent"
The brain is already boiling. : lol:
Please suggest a clear algorithm for creating an access point for my case.

Post has been editedlesha-faza - 23.02.13, 07:19

Reflecting, it is more and more confident that I come to the conclusion that when a router is in the AP state (access point) - Wxp cannot organize a local network on the machine: a network card-router.
Can someone tell me what values ​​to score in the properties of the connection over the local network?

Help with advice how to increase the wifi signal, usb Yota modem is connected via keenetic 4g, it works only on the first floor, on the second floor it does not catch, how can I increase the signal or should I buy the second router?

I add. The Chinese Wireless-N ap router with a SKU: 674 sticker and 300 megabits and 3G tags with a huawei e150 and e171 modem inserted into its USB socket works fine. bought at the specified link. seller verifiedhttp://www.aliexpress.com/item/High-qualit.../618978596.html

Post has been editedThe prince - 12.03.13, 19:00

k1987 There is a option to buy a second router and configure it in bridge mode. But the speed will fall by 2 times.
Another option is to try to run with the router on the first floor, maybe where it will catch on the second floor. And the version of one of the antennas perpendicular to the ceiling twist - it can help. Or buy a better antenna. : smile:

Post has been editedAragorn_ - 13.03.13, 22:04

And where can I buy an antenna? And what is it called? I Yandex some plates that gives

Here is the TP-Link TL-ANT2409A Antenna suitable?

Linksys WRT160NL
interfaces RG-45 * 4 (LAN), RG-45 (WAN) 10 / 100Mbps, USB 2.0
WIFI 802.11b / g / n-300Mbps
(SUPPORT 3G modems only with alternate firmware)

modem support

[/ url]




Post has been editedartem1701 - 29.09.16, 06:35

In my experience, Zyxel routers are currently the best solution for connecting to cellular operators.
3G-4G communications in the house, as they support the largest number of modems and the compatibility list constantly
grows, stably keeps the connection, and in the case of the modem disconnection from the BS (base station) it is practically
always restore the connection without a forced reboot. In addition, the model Zyxel Keenetik
It has two antennas with a gain of 5dbi, which is often enough to cover the wifi signal of the whole house.
Well, plus prostate settings is an important factor!
And among mobile solutions, Tp-link 3040 (with built-in battery) and 3020 are definitely the best.

Before using any router, you should update the firmware from the offsite; there are alternatives on TP-Link
You should not install the firmware with DD-WRT and OpenWrt without a special need, as you roll back to the factory one.
The firmware is not easy, but you can lose the warranty.

Post has been editedg4802 - 19.03.13, 13:55

How to make Flyer U12 stuck in Upvel UR-344AN4G get out of the Internet? On the PC it works, on the Android tablet too. I stick into the router - does not connect: unsure:

A year and a half I use 3020, v1.00. Used as a router for 3G, and as an access point to LAN. Hung on the balcony for 5 months and at -30, and at +30 - there were no lags (inside the transparent plastic packaging from some device). Katal throughout the region, worked everywhere. Regarding the restoration of communication - also can without rebooting, only it is necessary to set in the settings. In general - happy as an elephant.

g4802 Thanks for the post!

I chose a new router for a long time to partner with my DIR 320 (I use two providers at the same time), and finally I stopped at Zuxel Keenetic.
And then your post is just a topic!

The truth has not yet chosen between 4G or with two antennas (I did not understand what they say, the market is simply kinetics).

Of thesetwoWhat kinetics will you advise?

Here's an example today going to the cottage, I tortured the DIR 320 tortured, like the Internet to set up MTS-Connect, and like works. But by the end of the day such as an Internet connection is no longer, and that the most grusno it can not be restored even after a reboot of the router, or after disconnecting and return the modem. Shorter than 320 formally supports 3G modems, but in practice - not. Well, they say it is necessary to put the firmware, but I do in this regard is not very rukasty, so long as the Internet in the country will distribute Galaxy S3 mini as hotstopa. But it will agree not sports.

Just discovered that it turns out there are new models of Keenetic II. Madecomparisonon the market with old models

I understand there is a new percent, added RAM and some functional chips such as Yandex.dns.
I think now to take KeeneticII or KeeneticII Giga.

From the fact that there is no Keenetic II 4G router in the new line, I conclude that this model was unsuccessful and did not use demand

today bought mr3220 no russian

And did not try to update to the latest firmware?
I have after the update on the last one.

Post has been editedGreison - 15.05.13, 20:09