I decided to make a stand for the phone, spending a half day :)
Stand allows you to set your phone as avertically
so and horizontally
Connecting at the same time charging.
Model stands pile into 3ds max'e, and scan - to Pepakura Designer.
Printed on normal A4 sheets. After gluing (not the bottom) of the Internal pasted pieces of cardboard. The bottom of the weighted addition, an adhesive tape was knit mounting half of the transformer from the old table lamp, kraynyak fit and stone :)
Photo model and the finished "product" under the spoiler below.
In general, for those who have nothing to do enclose the pattern in pdf format.Dock_by_r0st.pdf
(22.39 KB)Post has been editedr0st - 12.02.13, 22:49