Jeka JK702 - Official firmware (OS 4.0.4) Jeka jk702Firmware пїЅ Instructions
I do not understand why the method of sabez firmware for dummies has not yet been described. Here called something like a manual. I was lying literally just that (by tyk). Television model JK702.
So.
1. Turn off the device. If you have a screensaver with a macaque in headphones, pump a needle (or something barbed) in the hole with the inscription R (reset) on the back panel, whatever it is.
2. Download drivers and program
3. Download the firmware file (for mine it has rolled this time
4. We connect the device to the rear port of the USB on the computer, clamp the volume button and the on button and wait until Windows is paying for that the driver is not found.
5. Unpack the folder on the computer archive with the RKBATCHTOOL program. Usually there in the catalog and firewood is also lying for our device. I made a screenshot that would be clearer.
6. We go to the device manager, find the "unknown device" there (attention should be exactly the case, and not Android Device! If the second, then we will try 4 item again), poke on it right-click - update the driver - we are looking for a folder, In which the archive with prog and drivers unpacked, click OK. Winda can make sure that the driver type is not signed or something in this spirit. Clay "still install."
7. Further by drip RkbatchTool and there in the section "Connected Devices" (connected devices) one of the ports should glow green.
8. In Rockcipe from above, where FW is written, press the button with a three-way, select the firmware file with the * IMG extension, and pump the UPGRADE button from below.
9. We are waiting for about 5 minutes until the firmware is filled, then checked.
10. When I write something like SuccessFully Done, click Exit, the tablet itself will go to the reboot, then we will make Wipe and, after another reboot, starts.
Shl.
1. Before the firmware, it is advisable to charge a tablet carefully.
2. Do not flash the tablet if there is no extreme need (for example, it does not load the system at all). If just buggy, etc. - Try to start restore the factory settings, well, or on the extrusion, Hard Reset from the recovery to do.
Post has been editedAUDIMEN - 28.12.16, 09:07