1st method: When preparing a program, the tablet should be disconnected from the computer.
1. Download
Phoenix USB Pro2. Download the firmware.
3. Install Phoenix USB Pro.
4. Run Phoenix USB Pro (if you run the program for the first time, you may be asked to install a driver, just press NEXT (N))
6. Then we poke "Image" and select the image (.img) of the firmware from the archive.
7. Press the start button and see that the red cross changes to a green check mark - this means that everything is good, you can go on, (the program window is very large, so who has a small screen resolution, you may have to move it slightly to the left, and then you will see that little crosshead)
8. Then, with the volume + button held down (this is the one that is closer to the on / off button), we insert the cable, then without releasing the volume + 6-10 times, we press the on / off button until you hear the distinctive sound of the device connection in Windows.
9. The green check mark should be replaced with a red cross, and then again with a green check mark, if the firmware has started.
P.S: Nothing will be visible during the firmware, you can learn about the end of the firmware by the inscription "Finish" in Phoenix USB Pro.
2nd method: This guide is also valid for the firmware to 2.3.4
And so, we will need:
Save all the data stored on your tablet to charge for at least 25%download
LiveSuitShe firmware (4.0 or 2.3.4)
1. Unpack the archive LiveSuit, run LiveSuit.exe
2. Once started seeing LiveSuit User wizard window, click YES
3. click Format
4. Next
5. Yes and choose our firmware downloaded previously and which we have already removed from the archive in the format * img
6. button
Finishdo not push!
7. Go to the tablet. on off button traps the tablet increasing the volume and connect the USB cable and press the right about 10 times the power button while still holding the volume increase.
8. Perhaps the first attempt does not work, because the installation will start a couple of drivers, after they will install a window with the Finish button will disappear and start the process of firmware.
9. The firmware in time a couple of times a window will appear, always click Yes.
10. When the process is finished you will see a window without labels. Congratulations firmware was successful, you can pull out the USB cable and turn on the plate!