Answer to your own
question. I had great help
amvei.
After I did not find a response, I decided to send SSD under the warranty. I exchanged SSD, I came new, but did not pass and half a year and the problem is the same (so I probably do not recommend this firm, well, this is not the fact that the factory firmware flies only so). I did not want to send any more warranty, I decided to reflash.
My steps were such:
1) downloaded from this
the site files.
2) disassembled the disk, there it is necessary to make a flat scuffer to make a gap from two sides and the cover will disappear
.
3) I looked at what my memory I had (alas in the firmware of this memory did not turn out, but the program "Samsung" was determined in the program)
.
4) inserted the jumper into these two contacts (you may have the location of the contacts Other, the main thing is that you have found where it is written by the ROM and that contact which is about the white rectangle, you need to close)
, other location of contacts
.
5) After connected to the interface (the computer is in the off state) SATA 3 and turned on the computer.
6) I went to the first archive clicked on "Scan Drive" and decided as a flash drive in 1024 MB
.
7) Next, I moved to the "Parameter" tab When the bunch of errors ignored or simply did not want to sew, began to change 3 parameters (indicated in the photo) and passed to other archives, then again to another archive and so on until I found the final one. With the final I flashed with the Hynix or Samsung parameters, I do not remember exactly. But when I pressed the MANUAL tab, I was given the memory of "Samsung 60 GB", but then I chose Samsung to 128 GB. In fact, I just came through Hynix, Intel and Samsung and that's it.
, Amvei has helped these parameters
.
8) When I found the desired archive (I helped the archive SM2246XT_MPTOOL_P0920A) ->I also selected the first time, the program did something in the progress column, the blue line was constantly filled, after that, as she finished, issued an error, I pulled out SSD pulled the jumper and put it back and then flashed with the same parameters. And in place where there was a word Test was a green circle.
9) everything. Then the disk earned and he will need to broadcast the sectors in a new way, whatever it is determined (as a new disk sometimes). Press the Win + R keys on the keyboard and enter the diskmgmt.msc to the "Run" window. If you do not figure it out further, look at the Internet, there are many videos about it there.
RESULTS:
My:
AMVEI:
In case of no working link, I attach an archive with archives
Archive.rar(16.17 MB)