> Attention!

New threads need to be created only inroot partition! In the future, they will be processed by moderators.


28 pagesV  « < 26 27 28 »  
 
REPLY
> Help and problem solving for flashing
stricke12
Message#541
01.03.19, 18:53
a guest
*
[offline]

Group: Users
Messages 2
Check in: 01.03.19

Reputation:-  0  +

hello help please kind people to find the firmware on the push-button telephone bravis f180 I will thank you in advance
green teapot
Message#542
01.03.19, 20:17
Local
*****
[offline]

Group: Friendssavagemessiahzine.com
Messages 381
Check in: 29.01.14
LG Spirit

Reputation:-  17  +

* stricke12, what happened?
stricke12
Message#543
02.03.19, 11:59
a guest
*
[offline]

Group: Users
Messages 2
Check in: 01.03.19

Reputation:-  0  +

The phone is screwed up, I want to reflash it, the whole Internet has been covered with no firmware file
green teapot
Message#544
02.03.19, 15:05
Local
*****
[offline]

Group: Friendssavagemessiahzine.com
Messages 381
Check in: 29.01.14
LG Spirit

Reputation:-  17  +

* stricke12, and a complete reset?
grab123
Message#545
02.03.19, 21:12
Novice
***
[offline]

Group: Active users
Messages 30
Check in: 11.08.10
Xiaomi Redmi 3S

Reputation:-  0  +

I have been using push-button CDMA + GSM + GSM phone Tintele C2 for a long time. On occasion, I bought the second one with the same fault - when turned on, the logo is displayed, and it hangs on it. The button turns off. Inside did not find anything suspicious. Onboard processors and scrapbooks. There are Rx, Tx, GND pyatics on the board. How to merge firmware from a working fluid and stuff it into a faulty one?
Old topics and links to instructions are broken and broken. Can someone have mercy and tell you where to start? I tried FlashTool according to the instructionsfrom this site, on the third paragraph stupor.
Quote: "3) Now turn off the phone. Remove the battery and insert it again, but do not turn on the phone. Connect the cable to the phone. In FlashTool, click the button" Read Back ". Now the program waits for a signal from the phone. when you release the button you will understand for yourself if the cable is working, as the red stripe below will go into FlashTool).

4) If everything went well, then the full will be read. "

When I click "Read Back", the window for opening a file is immediately expanded ...

Attached images
Attached Image
grab123
Message#546
06.03.19, 10:52
Novice
***
[offline]

Group: Active users
Messages 30
Check in: 11.08.10
Xiaomi Redmi 3S

Reputation:-  0  +

In general, it was possible to merge and fill the firmware using FlashTool_v3.1108.00. This version understands percent MT6253DN. Although the problem with the phone is not fixed - writes Low battery stop. After the firmware, already in English low battery shutdown. It is natural not to find a circuit, but checked all the resistances, capacitors for a short - the norm. Voltages are also present, except instead of 1.8V, it produces 1.5V. That's just who forms it, could not figure it out, the percentage seems to be alive - there is charging indication, button illumination and reaction too ... Near the quartz almost that signal form, but ... hardly.
beet06
Message#547
08.03.19, 18:42
a guest
*
[offline]

Group: Users
Messages 3
Check in: 24.02.19

Reputation:-  0  +

Good day, help me figure out how to reflash the nomi i243 button. Or how to unlock the password. There is a firmware with the .bin extension, but how can I flash it and by which program I can not understand
! cePe @ k
Message#548
20.03.19, 02:46
a guest
*
[offline]

Group: Users
Messages 1
Check in: 03.01.18

Reputation:-  0  +

Did you manage to find the firmware? Already everywhere I rummaged where I could. The problem is the same with the password.
Mantix
Message#549
24.03.19, 14:35
a guest
*
[offline]

Group: Users
Messages 1
Check in: 03.10.14

Reputation:-  0  +

Hello! Philips Xenium E106 Black requires a password when you turn it on. I tried all the factory 1122, 0000, and so on. The thought came to upgrade, I can not find the firmware anywhere, Google asked for a forum I was looking for. Can you tell me what? Thank you in advance!
beet06
Message#550
01.04.19, 16:19
a guest
*
[offline]

Group: Users
Messages 3
Check in: 24.02.19

Reputation:-  0  +

firmware like there is
But I can not find how to flash it (I'm not looking for it anymore)
zdanko44
Message#551
12.04.19, 12:33
User
****
[offline]

Group: Friendssavagemessiahzine.com
Messages 54
Check in: 11.07.10
Sony Ericsson Xperia arc S

Reputation:-  0  +

Hello to all! Specialists help with the problem. Phone from England, work, not stolen, you insert a SIM card writes
Phone restrictedpushUndowritesEnter restriction code: . Nokiamodel: 2330c-2 Type: RM-512, made in Romania.
How to decode, is it possible without flashing, are there any secret codes for this?

28 pagesV  « < 26 27 28 » 


 mobile version    Now: 04/18/19, 15:36