Copy the firmware image (SWUPDATE.BIN file) to the root of the SD card.
Connect the e-book to the power source (charger or computer) using a USB cable. During the entire process of flashing the book must be connected to a power source
Turn off the e-book.
For PocketBook 301+: turn on the device while holding down the “+” key on the right side of the book.
For PocketBook 302: turn on the device while holding down the two bottom paging keys at the same time.
For PocketBook 360: turn on the device while holding down the central control key and the top paging key at the same time.
Release the power button, the other keys release only the message “Firmware update” at the top of the screen.
The updater will validate the firmware image. If the verification is successful, the message “Press center key to start update” appears on the screen.
Press the central control key (on the Pocketbook 302 cancel / return button). Firmware update lasts about 2 minutes. If the update is successfully completed, the message “Update OK. Now please reset the device »
Pocketbook 301+, Pocketbook 302 and PocketBook 360 should reboot automatically.
Turn on the device. Check that the new software version is installed (“Settings” - “Device Information” - “Software Version”).
If desired, copy the updated games and applications from the software update archive to the device’s games folder, and the dictionaries into the system \ dictionaries folder (the contents of the internal memory and SD card do not change during the firmware process).
Once the update is complete, SWUPDATE.BIN can be deleted from the SD card.
Possible errors in the update process:
No update image found - the SWUPDATE.BIN file was not found on the SD card. Try to format the SD card (after saving all the information on the hard disk) and write the file to a blank card. If the error persists, try updating from another SD card.
Please connect power cable - the power supply is not connected. Make sure the USB cable is securely connected to the power supply or computer.
Update image is corrupted or Image is empty - the SWUPDATE.BIN file is damaged or there is no free space on the SD card. Delete unnecessary files from the card and overwrite the SWUPDATE.BIN file again. Repeat the firmware download from the site
http://pocketbook.com.ua. If the error persists, try updating from another SD card.
Firmware image is not for this device - you are trying to write software designed for another device. Download the update for your device from the site
http://pocketbook.com.ua.
File read error - error reading the SD card. Try updating from another SD card.
Flash write error, sector N - Error writing program to device. Try updating again. If the error persists, contact the service center to correct the problem.