slimest slimest @ 15.8.10, 12:31
-Qwerty-, let's not Tom audience kolis
Well, in general it's pretty simple. I eGo and atom course of 510 cigarettes ...
Parse atomizer COMPLETELY.
For this it is necessary to screw into place atom (ie in Accum) almost to the end. Stagger should not but the twist so you can not straining at all.
Now one hand we undertake on battery, the other for the atom. Spreading their start in different directions (atom while gently swinging).
The outer shell of the atom (cylinder) starts to slowly ramp up to the cap. The main thing very carefully and slowly to do it so as not to pull or tear away from the inside of the cap of the atom (though soldered wiring back problems should not be, but I do not advise).
As a result, must remain a hollow cylinder in one hand and the other on battery socket and internal atoms.
Now pick up the wick to replace. Height must occupy the entire space between the bridge and dispersion spiral. The wick should be porous, and very good to get wet, but at the same time and not let moisture (in this case, thinner) drip with yourself. Along the length of the wick should be such that it could curl letter S under the bridge.
Now remove the native wick. Our wick is clamped between one wall of the bridge and the porous metal sponge, and then under the bridge and hold fix from the other side between the bridge and the porous metal sponge. The wick is always or touches the heating coil, or in fractions of a millimeter hanging over it (it does not prevent fluid spill over into a spiral, and the wick is not lit).
The result should be that the entire surface of a spiral wick, but depression in the ground, which is a spiral, is seen with 2 corners diagonally.
During this manipulation is very easy to damage the atomizer. Metal sponge is practically impossible to compress, otherwise bad swill soaks the wick.
As a result, when the cartridge is inserted obtain that fleece in it all as a bridge prominaetsya, but all the free space is filled with wick. Here he plays the role of the protective fleece in this case.
Now, even drenched atom when inhaling slurry rises and gets to the wick means and will evaporate.
But he propylene glycol and glycerin are inherently insulators, so the Accum (if not modified) can be safely poured (at least in my contacts BATTERY leaking manure than once, and he was feeling fine).
PS I told you need pictures, and that 50% do not understand!
ZZY And with wicks tidy. wicks away
Slimest singeing must be very careful, not to fluff flew ...
Post has been edited-QwertY- - 15.08.10, 12:56