Mazepa2000 @ 07/06/19, 14:46
Guys, such a question. After completing the print, the printer raises his head and highlights the table, where in Kura, set a pair of a couple of mm less maxima, and then rest in the lid and makes the TRRRR motor? Probably, the mechanics is not particularly useful ...
I have a complete code for this. If you print high parts, you can remove the raising h at completion, but there 0.5 mm is not particularly and critical. Then the nozzle will go away.
M104 S0; turn off extruder
M140 S0; turn off bed
M84; disable motors
M107.
G91; Relative Positioning
G1 E-1 F300; Retract The Filament A Bit Before Lifting The Nozzle
To Release Some of the Pressure
G1 Z + 0.5 E-5; X-20 Y-20 F {SPEED_TRAVEL}; MOVE Z UP A BIT AND RETRACT FILAMENT EVEN MORE
G28 X0; Y0; Move X / Y to Min Endstops So Head Is Out Of The Way
G1 Y180 F2000
M84; STEPPERS OFF
G90
M300 P300 S4000.
In general, the print area is rigidly spelled out in the firmware. If you have no dimensions in Kura, they should not be exactly indicated. Can Houm raised too high? The beginning of the coordinate comes from parking.
Q.W.E.R.T.Y @ 07/06/19, 15:03
I just, when parking, the snot behind the table leaves, it is convenient to shoot in front of the seal to the table with tweezers.
It's buulshit. I was looking for a code for the operation of several extruders. So there at the beginning of the printing printer draws two strips from the edge.
All snot there remains, and not wound on the printout as with the skirt. Much more convenient to standard funds. And print skirt is no longer necessary.
https: //zemistr.github...oiner-gcode-generator/Here is the generator if it is interesting, you can see what code is generated for each line.
In general, if the nozzle parks away from the table, then you can put the brush there to clean the nozzle with the machine
Mechanism @ 07/06/19, 14:59
You have a little. I have 220 to 250.
It seems to be measured a month ago what is 220 * 220 and 220 * 240. Do you have exactly 220 * 250? Third option? Or you do not consider glass size and the size with the clips o_o
This tables are used as different goes now. great more
Post has been editedclawhammer2007 - 06.07.19, 15:56