File D41010d.tot available
hereLGFlashTool:
LGFlashTool_1.8.1.1023.zip(9.28 MB)
To start LGFlashTool, you need to place the file megalock.dll in the folder with the installed LGFlashTool
MegaLock.dll(6.5 KB)
Instructions for use LGFlashTool
hereDLL for our body:
LGD410_20140206_LGFLASHv160.dll(1.23 MB)
The instruction is not for our device, but on the whole is completely analogous! We act at your own risk !!!My firmware was successful ... I did not notice the changes visually ... For the time being it is not clear ...
Screenshot with firmware version
Attention! Firmware via LGFlashTool completely resets the device and kills the root! Make a backup of important data!While I found only a new wallpaper ... (((
I restored the root, there are no problems with its restoration. The firmware is also ruled.
Unsubscribe about operating v10d firmware based on four-day testing.
So, in the pros, we have (the data is not confirmed, all the information is exclusively on sensations):
Uniquely increased battery life (according to preliminary estimates by at least 10%)
Improved algorithm for calculating battery capacity, a more accurate prediction of operating time, no sudden subsidence.
Improvements in voice communication, subjectively clearer sound, significant reduction in the number of voice artifacts
Uniquely improved quality of work with tachim (as you remember, I wrote about the software method to partially overcome this problem, in the new firmware and without software adjustments, the touch works surprisingly well)
More competent work with memory. The amount of free RAM has grown by 15-17%.
Naturally not done without a fly in the ointment:
The radio module began to work worse. Optimization clearly improved the stability of communication (judging by the improvement in speech intelligibility and reduction of artifacts), but at the same time worsened (and even made impossible) reception in areas where the signal was initially weak. Subjectively, the phone became worse, “catching” the network by 10-20%. What is most unpleasant, it also touched WiFi and Bluetooth. I suspect that the software radio module has been completely changed in the new firmware.
Many copies in this thread are broken about the presence of a grid of high brightness on a bright screen. In the old firmware, I did not pay attention to it, it was almost invisible. In v10d, the visibility of the grid has increased about 1.5 times, and now at maximum brightness it is already quite annoying. If possible, chose wherever possible dark themes.
These are the changes in the new firmware. All changes are described only by sensations and in comparison with v10c, the software suite is the same. I ask you to unsubscribe if you notice something else or you do not find the changes that have appeared in me.
The official Changelog speaks only about improving the touch response.
Post has been editedevoname - 24.07.14, 11:40