The design of the iPhone has not changed in comparison with the predecessor. You need to start disassemble from two screws from the power connector Lightning, the screws retained the heads with the Pentalobe slots.
Next, too, no changes - the suction cup and plastic tool will help lift the display with glass. Next you need to stop.
The next step is to make it extremely carefully, in the iPhone 5S a new loop from the Home button, in which the touch ID sensor hid. This loop needs to be disabled before you continue further disassembly of the device.
In the iPhone 5S battery is glued to the case. Also removed auxiliary tail, which allowed to instantly extract the battery. The iPhone 5S broach is more capacious than in the previous model. The following parameters are stated: 3.8V - 5.92W / h - 1560 mAh, which gives a conversation time to 10 hours.
Then the protective plate of the Retina-display connector, dynamics and cameras are removed. Turn off tweezers. After you can remove the display module.
The iPhone 5S display module is further disassembled. A modified HOME button with sapphire glass from a biometric sensor is separated.
In fact, the Touch ID CMOS sensor is a set of very small capacitors, creating a "picture" with your finger terrain, that is, his imprint. The technology was developed by Authenec, which was purchased Apple over a year ago.
The topime camera with a 1.2-megapixel matrix, speaker and an approximation sensor are fixed on the top of the display module. Delete after removing the mounting plate.
The iPhone 5S hosts the main camera from Sony, the IMX145 model with a feedback, a similar model is used in iPhone 4S and 5.
After the three fastening screws are unscrewed by a cross screwdriver, which allows you to remove the motherboard, the most important components of which are protected by metal screens.
Consider a Read more iPhone 5S motherboard: the lower part of the board is loaded with a solid set of controllers, and a large microcham Nand flash memory SK HYNIX H2JTDG8UD3MRB with a capacity of 16 GB (red).
The main microcircuit on the top of the board is SOC Apple A7 - billion transistors, 64-bit architecture. Apple M7 coprocessor is built into the main system-on-chip SOC Apple A7. RAM is hidden under the processor, marking F8164A1PD, RAM in iPhone 5S 1 GB. An orange is marked by the Qualcomm MDM9615M LTE modem, yellow - Universal Qualcomm WTR1605L LTE / HSPA / CDMA2K / TDSCDMA / CDMA2K / TDSCDMA / EDGE / GPS Transceiver module.
The Lightning connector block contains several components at once: 3.5 mm Jack, microphone and lighting connector itself. Repair iPhone 5S: replacement of the lower loop will not be cheap operation.
New dual flash iPhone 5S. At the top of the smartphone there is a vibromotor for a call, Wi-Fi antennas and GPS.
Deleting the latest items get a pure gold casing iPhone 5S. The assembly occurs step by step in the reverse order.