Tell me please. Preparation is made according to the instructions (not the first phone), trying to revive the MT6589 brick issues an error (4032 or 0xFC0) S_FT_ENABLE_DRAM_FAIL tried all the methods specified in the header with this error except closure 4 and 5 USB contacts. When connected, writes
After not a good firmware, if you pull the cable without distorting the battery and insert back it turns out so.
But the firmware does not begin. There is a third option. Preparation, not successful firmware, without turning off the cable Run the firmware again the same error, pulling the cable, insert back and turns out so.
Post has been editedandrei25025 - 31.01.17, 17:03