Rep: (3)
Caminwat @ 10/20/2015, 23:16*
The native dialer does not allow you to associate contacts with a certain, right? About the associations on the masks of numbers I'm silent. There is a good diagnostile (Pixelphone), used on the previous one (there was 4.2.2 android), that's all this in it. I put here - then there is no set, then the set is only with one .. It is clear that the case in the program is more, so the question is - who cares? After all, the second SIM card was not for beauty? And the stock ring uses it in full does not give unfortunately. Permanent manual choice ... Hmm, well, so-so a solution, honestly
PS Well, and screenshot After replacing the MTS SIM cards to a new with support 4g


1. Communicated with support. Bring contact to SIM card can not
2. If you click on the number of numbers and hold, select SIM card and put a checkbox "more" not to ask - it's all calls
3. Pixelphone is also there. It works great. Only there is a nuance. From the previous phone, I pulled out the saved settings for it. As a result - the dialer falls off (even regular). Cured with a clean Pixelphone and setting from scratch



Rep: (3)
Today I purchased the 500th. There were questions:
1. How to bind contacts to an outgoing call to a specific SIM card?
2. How to prohibit sending SMS from the second sim card?

thank



Rep: (3)
Hello. I look at this unit. There is a very important question for me. How does he "hold" navigation in motion? I sell the current phone due to bad navigation (on the road can suddenly lose all satellites). The speed of finding is not as important as "chain" to the signal.



Rep: (3)
How as ASUS compared to LG Magna H502, Huawei Honor 4c?

Post has been editedzed45 - 13.10.15, 13:12



Rep: (3)
ANVN @ 12/29/2014, 16:16*
With version number 1, you can use absolutely any folder (how long enough of your fantasy). What is the problem?


You need to save on the memory card built-in camera. How?



Rep: (3)
ANVN @ 12/29/2014, 16:02*
Option number 1 - Use a third-party camera with a similar functionality (for example, Camera FV-5).
Option number 2 - ask your question in the relevant topic.


Option number 1 I use. But in this case another problem Yandex.Disk arises. Yandex.Disk synchronizes pictures only from the folder where the standard camera folds. As a result, the pictures from the Camera FV-5 from the memory card are not synchronized.

Option number 2 - What topic to ask a question?

P.S.
Problem specifically to customize storage pictures from a standard camera?

Post has been editedzed45 - 29.12.14, 16:14



Rep: (3)
Good day.
Firmware G4S-20141022-222444 (Android 4.4.2 V6 for Jiayu G4S)
On the firmware 4.2.2 in the camera settings, it was possible to specify the storage location of the photos (on the memory card). In 4.4.2 there is no such setting. How to get out of position, I want to save pictures to a memory card?



Rep: (3)
Problem with bluetooth
Phone 2/16 GB.
Firmware official Last 4.2.2 (I tried the last leva)
The phone in the machine is connected via Bluetooth to the balalaica.
When talking there is a constant crackling, so that the interlocutor is not heard. If you turn off on the phone, and then turn on the Bluetooth, the first two calls are still tolerant (more or less audible interlocutor), then again noises. The usual conversation without Bluetooth passes well, without complaints.
I changed the Speech Enhancement parameters in the engineer - does not help. Where to dig? Help.

P.S.
With all previous phones and smarts on Android (Acer, Asus, Samsung) there were no problems.

Post has been editedzed45 - 17.07.14, 12:08



Rep: (3)
Zed45, And if you change the SIM cards in places, is it still the first one?


So the first is micro, and the second is ordinary. Therefore did not try.

Post has been editedzed45 - 11.07.14, 15:42



Rep: (3)
Alexh11 @ 07.07.2014, 15:32*
[email protected], 15:27
Forgot to specify: data transfer through the first SIM card

Moreover, then such an outcome of events is very likely, try to find this switch, I do not exactly remember where, but now I unfortunately did not find it in the settings.



Summarize the problem and conditions
There was a problem connecting the second SIM card.
Official firmware for Jiayu G4S (2 / 16GB) v.20140609-211642 dated 12/06/2014
The first sim is Megaphone,data transmission 2G / 3G - automatically - 3G mode is enabled for this SIM card
The second sim is Tele2,no data transfer

When Don was the first Simka - everything was fine. I put the second one, when talking over the first one, the connection was lost (i.e., the conversation ends). Through the menu, turn off the second SIM, the problem disappears. Who knows how to cure a problem?

P.S. switch not found

Post has been editedzed45 - 11.07.14, 14:39



Rep: (3)
Alexh11 @ 07.07.2014, 15:24*
[email protected], 14:24
When Don was the first Simka - everything was fine. I put the second one, when talking over the first one, the connection was lost (i.e., the conversation ends). Through the menu, turn off the second SIM, the problem disappears. Who knows how to cure a problem?

In general, this should not be, but anything can happen, perhaps the data transfer priority is before the voice, for example, if the second sim card includes data transfer, but mine is now in the settings on our body in the stock firmware this is not.



Forgot to specify: data transfer through the first SIM card



Rep: (3)
There was a problem when connecting the second SIM card.
Official firmware for Jiayu G4S (2 / 16GB) v.20140609-211642 dated 12/06/2014
First SIM - Megaphone
The second SIM - Tele2

When Don was the first Simka - everything was fine. I put the second one, when talking over the first one, the connection was lost (i.e., the conversation ends). Through the menu, turn off the second SIM, the problem disappears. Who knows how to cure a problem?



Rep: (3)
Question.
Is there a difference in the speed of the native SGS3 charging the charger and the battery charger from the samsung galaxy tab?

In the charger from Taba current 2A, as well as medium-sized contacts (they are closed), the voltage of about 1.2V. Rodney average charging contacts (D + and D-) are closed and there is no stress on them.

The goal: to make the adapter "USB Dad -<shemka voltage divider to input pins 2 and 3, voltage 1.2V>- USB mom "



Rep: (3)
MK69 @ 08.08.2013, 01:56*
I rolled back at 2.3.3 and updated the database again from scratch. All recipes and photos have been added again.


And where to get version 2.3.3?
In the header only 2.3



Rep: (3)
abilit
THX



Rep: (3)
And what is better for the child (games, video, a little internet) to take it or Hyundai T7S?



Rep: (3)
Son "too fast", so I think the bumper, and for the carriage of the pocket



Rep: (3)
Hello. I conceived to acquire this device for my son (7 years). What will be better to buy a cover or rubber bumper to it?

P.S.
Does it make sense to buy this tablet or buy analogue?



Rep: (3)
The only reason for using the Opera: Bookmark Synchronization. After "joke" in version 14, killed her. And chrome mobile and desktop synchronizes bookmarks?



Rep: (3)
Refueling No. 1 (44857 km) 55.42 l to full tank
Refueling number 2 (45422 km) 33.67 l
Refueling No. 3 (45706 km) 50.89 l to full tank
No no records


To calculate the flow rate of 100 km, the first refueling cannot be taken (you can only for new machines), because mileage on gasoline = mileage в„–3 - mileage number 1

Consumption100km = (Volume number 2 + Volume number 3) / (mileage 3-mileage number 1) * 100 = 9.96 l / 100km

The program takes into account the first refueling and consumption of incorrect 16,49 l / 100 km

Author Correct the calculation algorithm!

Full version

Help     rules

Now: 09.02.21, 08:33