Rep: (20)
Rusgad05 @ 07.27.19, 13:04*
Hello everyone, I have a laptop with the trash of a dead body, and with critical overheating at 85 degrees (cleaning, replacing the thermal paste does not help)
Model 20150, intel core i-3 2370M 2.40GHz, Nvidia 630M.
So, I would like to shove the Mat motherboard in the PC case and attach the screen to it,
Has anyone got up this here? I would also like to know which video cards from stationary PC will fit this model and what percentage should replace the old one, as well as which block to take, in general, everything is all, since I do not really understand and I did not assemble a stationary PC. Thanks to all


It was.
85 at the peak is the norm, especially since the body is in the trash (separation of air flow, everything is done. Blowing and blowing. The case is also an element of the cooling system.) With a video card, put it into the pci-e connector instead of wifi, for example (adapters from 1000 on Ali). The throughput is fairly limited, therefore, only vidyuhi generation to gtx960.
For the rest of the points - google. Things are native, if there is not even a rough idea - you should not even begin.



Rep: (20)
Nikulyar49 @ 07.20.19, 19:03*
RGT72 @ 07.20.19, 18:48 *
And the personal experience of ordering this battery is?

Of course not. At 6500 mAh is not worth it. Better than 4400 mAh. For a more powerful network adapter and need more powerful.


Rave. If instead of the native charging insert a source that gives at least 9 amps at equal voltage, the charge controller will not skip this current one fig, cut it off. It makes no sense to argue, we buy a multimeter and "crash" the probes into the positive contact of the charger.

The only minus from the battery of increased capacity is the charge time. The difference in charging time from 0 to 100% will be approximately 50%. At the same time, we increase the operating time of the laptop by 50% relative to the standard battery. Well, of course, all of this is only on the condition that the Chinese stuff a "honest" 6500 pm. ..: yes2:

Post has been editedtimurmurmur - Yesterday, 02:00



Rep: (20)
Hello. What is now to replace Makimusu, fresher with the sense? S-OFF and so on there. When the battery is discharged, the phone just cuts, as a result, the minimum settings are lost - the wipe section date or cyclic rebuses, as a maximum. There is no similar cusp on any other firmware. Half a year on LOS 15.1 - peacefully writes off at a low charge, keeps everything on and off.



Rep: (20)
My five kopecks. The device has been in operation for two years. Report.
No complaints in terms of software - everything is clear. The connection is stable, the discontinuities due to the transition to android wear 2.0 are completely gone. The battery keeps stable for two days.
Now for warranty service. It's hard. Initially, the device bought with a leather strap. The first ring, into which the second part of the strap should be inserted into the belt, the other one dangles. The diameter thereof is one third greater than it should be. In the course of operation, a year later, the speaker began to play quietly - it became impossible to use the clock as a headset. Bore in warranty. Indicated this defect, plus noted the strap. Call in a day. Give a new watch with an old strap. Thanks, but. Three broken pixels that are lit in red on a new clock in the display off mode is a brute force. The exchange is denied, they say, in the normal range. The second ring on the strap, naturally falls off after. Service is fire. And huawei marks in the "A" brands after that?

Post has been editedtimurmurmur - 31.05.18, 02:11



Rep: (20)
YuRiEL_G21 @ 03/17/2018 10:44*
In case someone missed. Found versiongoogle camera which fully works on 15.1. * For video selfie in the settings, select 720hd
swayhere
fire, on the RR-O-v6.0.0-20180209-m8-Official got up like a native! Futezh camera worked the day and began to crumble. There is something to replace now.
I did not find the item in the settings to save to an external memory card. Minus :(

Post has been editedtimurmurmur - 17.03.18, 11:09



Rep: (20)
At 15.1, who was able to adjust the weather in the widget (cLock)? He does not want, as he did not butt. o.O
Put suppliers from here -https://download.lineageos.org/extras



Rep: (20)
__taurus__ @ 03.02.18, 15:18*
the sensitivity of the top of the screen suddenly stopped working

There was a couple of devices. Connector flooded on one, blade controller tacha on the other. I advise you to dig in the direction of "iron"



Rep: (20)
Pepetz @ 07/27/17, 16:49*
Who changed the camera?

Put on m7, the cameras are the same. On Ali, if you search, then you need to take lots with the note "there is no purple hue."

Post has been editedtimurmurmur - 28.07.17, 06:35



Rep: (20)
There are a couple of devices: htc m7 and m8. Both on 13 cyan (lineage now).
Has anyone with the size of the system partition been played?
Devices with c-off, of course. How much would be best personal experience? For 4 GB under the system is somehow very fat



Rep: (20)
Duc with M7 is the same, you can even expand. one fig sections repartition
sorry about odnosymochnik. Dual did not understand.

Post has been editedtimurmurmur - 24.07.17, 06:34



Rep: (20)
Super. Thank you +
Has anyone with the size of the system partition been playing on a cyanogen / lineage?
Device with c-off, of course. How much would be best personal experience? For 4 GB under the system is somehow very fatty.



Rep: (20)
Guys, cyanogen 13 who left? Links are dead ... Linyaga either.
14 do not want to put.



Rep: (20)
Hello everyone, I'm trying to put the last official cyan on the Rostest's 816 dualsim. Tvrp, as well, the last one gives an error after selecting and checking zip with cyan, saying that the factory should be done. Who met similar?
device - boot unlocked, tvrp 3.0.2, s-on


The people, no one is sitting on 13 cyan or what? : blush:
can't install this package on top of incompatble data

http: //s014.radikal.ru…03/10/d8d53848b2c4.jpg

Post has been editedtimurmurmur - 21.03.17, 01:34



Rep: (20)
Sdekapil old etchisi on android 2.3. Works, good prog.

Post has been editedtimurmurmur - 07.02.17, 04:04



Rep: (20)
Hello everyone, I'm trying to put the last official cyan on the Rostest's 816 dualsim. Tvrp, as well, the last one gives an error after selecting and checking zip with cyan, saying that the factory should be done. Who met similar?
device - boot unlocked, tvrp 3.0.2, s-on



Rep: (20)
Logan-trall @ 11.12.16, 16:30*
Why is this? You need an unlocked bootloader and cast recovery.


Understood, then this is only for flashing the drain from another cid, or lowering the software version?
Then, in dogonku ....
What assemblycm13 Is it currently relevant for the single-value version of the device? Does anyone use on a permanent basis? Cons of the iron part, in terms of energy saving or camera quality, for example?
On the droid dna stood - grief did not know. But there are official assemblies, as on the 816th dual-purpose. But I did not see the odnosymochnik, only I found the 12th version on getcm.

Post has been editedtimurmurmur - 12.12.16, 15:58



Rep: (20)
I understand that a cyanogen, for example, the 13th, cannot be put on a single-unit device with snapdragon without s-off?



Rep: (20)
This


definitely not play on that gland.



Rep: (20)
hello everyone i'm trying to dos-off - ram runner stops on checking for updates. Does anyone have any ideas?
The phone for Hong Kong is led 622, it is unlocked, there is a root, twrp recovery, custom kernels re-tried everything.

the log is attached.

==================== rumrunner S-OFF 0.5.6 ======================= =======

rumrunner S-OFF comes with NO WARRANTY (express or implied)
and NO GUARANTEE OF FITNESS for any particular task.
This is a safe process for users.
however your authors disclaim your phone
or other materials or devices used during this process.

Rumrunner S-OFF lies with you, the user.
By using this software you acknowledge and accept that the authors
are not liable for any loss caused by materialso otherwise caused.

Do you understand the implications of this warning?
(Yes / No)
Yes

Dear User: We will expect that YOU:
(1) Know how to use ADB and FASTBOOT binaries
---- [Yes, use BEFORE running rumrunner USB connection] ----

(2) Realize that rumrunner S-OFF cannot support every custom rom in this world
(3) Understand that irc support IS NOT A GENERAL HELPDESK
(4) package for your device
(5) Know how to enable USB debugging on your device (Yes, do that now)
(6) Understand that you may NOT repack or redistribute rumrunner S-OFF

Ok?
(Yes / No)
Yes
!! Do not for any reason, unplug, drop, eat or pet your device !!
Please wait ....
..........
Checking for updates ......
ERROR: Cannot check for updates
Press ENTER to exit



Rep: (20)
Hardware problem, modules from m7 are great. changed, more than once ...

Full version

Help     rules

Now: 07/31/19 11:41