Mr.Hunt,
Yes, a reset is required.

Posted 07/07/2019 11:20 AM:

The address will be visible in the web interface.

fanep,
I never doubted that this key could be restored.
Most likely, this can be done by restoring the partition from the dump.

alexlaz1982
He probably spied it in the E5372 thread. And forth32 described both "numbers".

Stay on them.

alexlaz1982
Well, sfm should not be taken.

Posted on 07/21/2019 5:57 PM:

Buttons in the download also did not work?

alexlaz1982
And how did they differ from ordinary .778?

These are sewn without a “needle”, for them the old mod is used as a “tipple firmware”. firmware .778.

Updatedmodified web interface.

Changes from Mod1.2:
- Allowed to use Wi-Fi channels 12.13 for s-23a and s-65a modifications, as well as 1,2,3,4 for s-65a and s-95a
- Unlocked mode selection 802.11 in Wi-Fi settings
- IPv6 support is activated (IPv6 in profiles is enabled and disabled by the commands enable_ip6 and disable_ip6, respectively; changes take effect after resetting the settings)
- Expanded list of selectable languages
- Restored VoIP settings on firmware 11.1xx.xx.xx.xx
- The official mobile application "HUAWEI HiLink" with firmware 11.1xx.xx.xx.xx has been restored

Post has been editedrust3028 - Yesterday, 09:42

For non-biline web interface _S _AT_04.01 must be set.

Bugaga1337,
The message also says "available for paymentsbalance. "The team is different.

Bugaga1337,
And if you follow the advice and dial * 100 * 0 #?

nubovshik,
Change IMEIa script.

terenty79
And if "LTE only" set?

alexlaz1982
Yes, everything is as usual. firmware.

nubovshik,
"Needle" does not work. You can sew only 22.286.53.05 .161 or fashion based on it.

dr_esin,
There is also a "gateway with network card" mode. Worksin Linuxand potentially in routers.

iZ01at0r,
Need to sewInstructions for B310- through the "dummy firmware".

dr_esin,
No, there is no Nat in the gateway.

dr_esin,
Switching (or auto-switching) in gateway mode ... But the kinetics do not understand this mode.

It can be disabled only with the AT ^ FREQLOCK command.
No applications are able to manage the aggregation.

Post has been editedrust3028 - 20.07.19, 11:16