My new capacitors with a battery to save the settings also came. But after replacing the capacitors, the last file is still not saved (
I measured the voltage on the capacitors when the BP is connected to the power supply and the BP is turned on, charging no higher than 4.3V, but if the BP is turned off but not disconnected from the power, the capacitors are charged up to 4.9V. And if again to include BP they are discharged to 4,3V.
And when looking at the board in detail, I noticed that the two outputs of one of the microcircuits are closed ...
Who has the opportunity to look at you the same?
And to what voltage are the capacitors charged?
Post has been editedhamster89 - 31.01.17, 23:13