I had a chance and decided to try. The mini Padavan firmware is not mine and I’m not sure about it completely.
He took off nand put spi, voluntarily picking up spi percent refused, connected the ground and TX from the adapter
UART-USB to the console, plugged into the computer and powered on the router. I started and the wires are no longer needed, until the next
on-off, and wan with lan2 swapped. Unfortunately, the decision is not final and requires doping.
Well, so it works. I think nand can not be removed, but only lift 9 foot and apply 3.3v through 10k to it.
In the future, by not complex switching, it may be possible to start with either spi or nand.
I nand shot for firmware.

I'm really looking forward to your manipulations, it can breathe new life into other devices.

and the meaning? on the stock in the same way die

Do you guys try to solder the memory or do not want to try it?

such for example 25Q128FVSG
пїЅ#пїЅ


But this is only an assumption, I do not have a subject, I personally can not check
But if someone understands the Ubutrub, then you can teach people to restore in this way)

First of all, I would check the pinout of this site in the center, and if there is food on it and it is on the correct pins

In a related topic, it seems they found
cause of death of routers.

In general, I have a MI-3 router, firmware from Padawan.
Everything worked perfectly today, but when awakened, discovered that the router is working and no Internet (all diodes are working in normal mode). He climbed from the phone to the router settings, let no problems on the home page showed that the network cable is not connected, I physically checked the condition of the cable and everything was working as it should be ... ok, I did a restart of the system via a web interface but after restarting it if he died. In the diode does not work at the front panel, rear cables connected to blink green (synchronously). Login to the web interface does not work, hard reset does not work .... (((What are they doing, tell me please