Installation instructions TWRP + ROOT [Magisk]
0. Unlock bootloader >>
as? 1. Download this archive>>
adb.zip(1.07 MB)
2. Unpack it to the root of drive C
2. Download
anyRecovery from the cap.
3.
Enable the display of file extensions.(after following this instruction, you can turn it off)
3. Rename the downloaded recovery to "recovery.img"
4. Transfer recovery.img to the root of drive C, to the adb folder (it should be if you performed steps 1 and 2)
5. Download boot image from
of thispost (in that post it is written for which firmware which boot, if for your firmware there is no necessary boot'a, then nothing will work out for you)
6. Rename the downloaded boot image (let's say you downloaded boot1024mi_JUN_magisk.img) to boot.img and drop it into the root of drive C in the adb folder where you threw recovery.img
7. Turn off the phone
8. Put the phone in fastboot mode
djsoo47 @ 1.08.19, 23:45
To do this, in the off state, hold down the volume and power buttons. A hare will appear on the screen in a hat repairing the phone.
9. Connect the phone via USB cable (original out of the box) to the PC
10. Download and install driver
adbdriver.zip(9.22 MB)
11.1. On the phone hold down the volume up button
11.2. Go to the root of the C drive, to the adb folder (where recovery.img and boot.img were dropped) and run the install.bat file
12. After a couple of seconds, the phone should reboot into TWRP
If you see something like this
It means everything is OK.
For installation
ROOT : on phone download
this file and flash through TWRP.
Post has been editedNo_Hammer - Yesterday, 18:02