Darenn @ 05/07/2016, 17:22
I wrote everything before and described. Now I wrote what to do if the drivers are not put.
Maybe the cause of the driver does not work is that 1 time did through USB3.0. But what's the difference ...
Where to remove them from the registry ... how to find them?
In folder
C: \ Program Files (x86) \ SPCA6350 PC DRIVER \ file
Unistaller.exe. , removes from the driver system, then you can go CCleaner.
All the ways that are written in the registry are in the INF files, you can manually clean.
Yes, and try to put a virtual machine and Win7 on it, we will be less problems =)
Gajil @ 05/07/2016, 15:16
Dear! And who does it use when shooting? And how long do you write down in what mode? It collided with overheating. It is very hot after 20-30 minutes goes off in 1080p60 mode and very very hot! The mode of 720pro60 or 1080p30 is not so much heat and work longer, but the fact that even it is at the temperature limit. I think it is possible to make something type to put a small plate aluminum on heating elements. As I understand it or the card overheats, or some part of the type of processor or that there is still there + heats the card and all this together gives the effect of care. I saw here one screwed holes in the chamber but I do not want to sleep yet. The camera never disassembled, but watched the visions and flattering there until no hunt. But if there is something constructive then I would open. Maybe you can stick to the latter of a small radiator that, at least something somewhere drove the heat. At the 720pro60, it was too warmed up much but 84 minutes worked did not turn off, then I myself turned it off myself just already tired of it She is a few hours in a row. Mode 1080СЂ60 The camera does not withstand or can not withstand the memory card itself. If during recording it pulls the card about the camera in 2-3 seconds will go to off. Are there any thermo films that protect against overheating? Maybe how to protect the card with this film so that it would not overheat? So far I think that overheating is the card that leads to a cloud of the camera.
I wrote down an hour in 1080p 60fps problems with shutdowns, lags and freezes were not.
In order:
1. The percent is heated, very wild more than 80 degrees.
2. Hot air rises from the processor from below - up, which means that the holes are mainly not helping to bottom.
3. The radiator inside will not help, as it cannot be cooled.
4. No thermal film will help cool the card, heating goes along the board itself.
5. Holes better drill in the housing where insert the battery side and where contacts (inside they are imperceptible), it will be distributed over the top of the case.
6. Better at the top of chosen (where the microphone), I think so ... But there is a pre-needle for a needle so that the drill does not jump (inside the porolon do not shove, the heating will be greater), a small piece of foam rubber can stick to the microphone itself.
Post has been editedMultisoft - 07.05.16, 20:02