Greetings gentlemen. Immediately I apologize for the wild offtopic, but the profile topic just do not have people with the necessary knowledge for my problem.
The situation is as follows. I nastoyaschik MacBookPro, 2011 from dying a discrete graphics card.
I use insertions, I in most cases it is enough with his head. But that would not run diskretka when the computer starts, each time have to dance with the tambourine.
Namely:
1. After starting up, run terminal & enter same code above (plus sudo) and password when prompted "sudo nvram fa4ce28d-b62f-4c99-9cc3-6815686e30f9: gpu-power-prefs =% 01% 00% 00% 00"
2. Start gSwitch and click "Open Advanced Pane"
3. Set GPU State to gpuState 5 and arg 3 and hit run, it'll affirm "Successfully set state: 5 and arg: 3". You may now close gSwitch if you so wish.
Help automate this process. I understand that this is possible to write a script that will run itself at startup. But to my knowledge it is not enough. Who can help, it is better in PM that would not clog the topic.