larry_one
iskesully,

Xiaomi R1D router with the HDD, but the point is that I do not need a router or my not optional. The signal I want to take the phone, ie you just need to strengthen 4G without electricity 220 volts, if it is possible of course. Or I did not understand the way you think :)

Post has been editedDiUser - 16.08.19, 13:02

Greetings
Advise decision please. The apartment has cable internet with a router. Periodically disconnect electricity from 1 hour to 12 hours (rarely) in average. The apartment takes Tele2 (only) with a floating 3G signal strength, H, H +, if you stick a hand out the window, the 4G one or two scale divisions.
Question: Is it possible to enhance the stability of the Internet signal to 4G without electricity. If so, how? I understand, you need an antenna with an amplifier, or just an amplifier with a built-in antenna, but what about the lack of electricity?
Thanks in advance.

But how to do it?

me too =)



Where exactly in the telegrams?

Post has been editedDiUser - 02.07.19, 13:50

I went to the regional CSN, said that until August TV sets will not be, as they rolled pieces 1k, 3k and pre-orders. Just action is over.

It's a box of L55M5-5ARU?

Do you what model, 4S or 55 L55M5-5ARU?

And you are sure that L55M5-5ARU - this is the 4S? In yamarkete - two different models, a feeling that under the guise decided to just shake off L55M5-5ARU. Announce that it was 4S, and not some L55M5-5ARU originally from 2017

More to the topic Amlodzhik percent, and in the new TV - Mstar. Perhaps they somehow work differently, well, firmware probably not suitable for the Chinese, just different percents

And Xiaomi Mi TV 4S there is HDR? There as something incomprehensible in Speke says:
* Compatible with HDR. This means that the processor supports HDR.

vip.kira.kf,
to Leberg suitable remote from Midea

You stopped charging in the on state, turn off the phone, connect the charging - the indicator is on, but it does not seem to be charging or is very slow. I threw off the lid, pulled the plugs of the bottom USB board and batteries, the phone began to charge. I collected it back, it does not charge again. How to determine what it is? Power controller or USB shawl bottom?

Interfere,
Thank you, I wonder why they broke everything))

On stable, too, flew 2.26.1, did anyone update, too, everything is bad?

Tell me what network frequencies are by default in the engineering menu?

Tell me, I changed the display in the service, after that, in the room, the network stopped to catch the phone at all and began to eat the battery. Could it be that they didn’t connect any cable there?

legionsavagemessiahzine.com,
And the bluetooth remote from the mybox can somehow be fitted?)

Thank! And how does it feel?

Post has been editedkvorus - 13.01.18, 22:28

What is this? Can I link?

And it is possible in more detail how to make?)