Rep: (369)
SILVESTR_FENIX @ 08.24.19, 3:23 p.m.*
Further, the mod simply disconnects any power supply (even from the computer), and does not accept charging.

How did you check this? What turns off completely charge? According to the display on fashion or some measuring devices?
P.S. The fact is that now, for many mods, the CV charging mode does not appear on the display, but nonetheless, charging is in progress.

Post has been editedAlexnight - 24.08.19, 15:54



Rep: (369)
K
Once again, I remind everyone
1.6. Adhere to the already established culture of communication on the resourcesavagemessiahzine.com. We ourselves create a habitat. Let's be polite and friendly to each other! If you see violations of the Rules, or you are provoked by other participants, do not go on about the violators. Write a letter to the moderator of the resource indicating the violation or use the "Complaint" button. The rest is the responsibility of the administration of the resource.



Rep: (369)
Krisans @ 08.21.19, 19:41*
Advise a device for soaking salt nicotine with a cartridge, in which you can pour yourself

Joyetech EXCEED - GRIP -



Rep: (369)
K
1.6. Adhere to the already established culture of communication on the resourcesavagemessiahzine.com. We ourselves create a habitat. Let's be polite and friendly to each other! If you see violations of the Rules, or you are provoked by other participants, do not go on about the violators. Write a letter to the moderator of the resource indicating the violation or use the "Complaint" button. The rest is the responsibility of the administration of the resource.



Rep: (369)
You can save and take a set with a good cashback - Club of fans overseas shopping (Post vladigor # 88081506)

This vaptio (and not only this one, but almost all the mods from this company), firstly, is very amateurish. For comic book lovers)
Backlight ... this is again for lovers, but I don’t know what, definitely not comics. It’s good that you can turn it off. But here again the trouble awaits in the form of its inclusion every time after changing the batteries. That is, every time after changing the batteries, it must be turned off again.
Further, he is healthy, really healthy for a dual-battery mod. Not individual measurements of height, width, etc., but its general appearance.
Also, the fastening of the battery compartment in the form of a plastic latch, very small, raises doubts about its durability.
More about batteries, the button that throws them out. What for? It is possible to block the fire, but this button cannot be, and, as a result, periodic clicking on it (random) in your pocket or something else will eject the batteries.
The cover is very poor quality, quickly covered with scratches.
A key instead of a fire button (but this is my subjective opinion, I just don’t like keys, I constantly press them involuntarily when I get the mod out of my pocket or when I use the mod while driving)

Maybe I forgot something else. But...
All this is true for its starting price of more than a hundred dollars. For the price that is now set for him on Ali, you can buy to play. But as a serious mod, I would not consider it. Even for that kind of money.

Post has been editedAlexnight - 19.08.19, 11:52



Rep: (369)
Dreamer @ 08/14/19, 11:43 PM*
istick mix see more

which manufacturer recalled due to the fact that they burned? And, I think, not all stores returned defective fashion and continue to sell them.



Rep: (369)
PowerfulSpirit @ 08/13/19, 20:29*
Are there any convenient alternatives? To + - compact, with convenient charging, refueling and a capacious battery for at least 400-500 puffs?

Joyetech exeed grip. But this is a slightly different form factor. Just joule-like devices, they are all with a not very capacious battery.



Rep: (369)
With aikos-like questions it’s better to address in a different topic:Club of users of tobacco heating systems



Rep: (369)
Zobaken @ 08/12/19, 1:01 PM*
in parallel, the capacity increases, and in the last the current output, no?

in the last voltage increases, it is equal to the sum of the voltages of the batteries included in the circuit. The above picture is true for the case when all the resulting voltage is consumed (doubled if there are two batteries). But if the voltage remains the same as it was when using one battery, the capacity of the entire assembly will still be greater than the capacity of one battery.



Rep: (369)
Ezio_leha @ 08/10/19, 19:30*
except in parallel batteries, I thought there last

And in the last tanks do not add up to you?



Rep: (369)
JAW @ 08/07/19, 00:41*
Molicel p28a.
At least very similar ...

most likely they are, the similarity is very strong.



Rep: (369)
* Jaw
* [email protected],
* dampirby,
K
Discussion moved to topic:Club batherssavagemessiahzine.com


Post has been editedAlexnight - 04.08.19, 03:21



Rep: (369)
K
I appeal to everyone, please follow the rules of the forum. Specialparagraph 4.9. It is forbidden to use obscene language, either explicit or hidden, including behind special characters.



Rep: (369)
Zavodnoy86 @ 08/03/19, 12:04*
3000 mach and more?

Well, here you already see what capacity you need. The larger the capacity, the greater the autonomy.



Rep: (369)
Zavodnoy86 @ 08/03/19, 11:55*
Now you need one battery for MTL.

for mtl any one is suitable, just if you need more autonomy - then choose from the most capacious



Rep: (369)
Zavodnoy86 @ 08/03/19, 11:43*
Which battery is better to use on a single-battery varivite for MTL? Need good autonomy.

Samsung 30Q will do



Rep: (369)
FD_KIM @ 07/30/19, 10:39 PM*
I want tal, duralumin

what's the difference? The taste is not the same or what?



Rep: (369)
FD_KIM @ 07/30/19, 10:21 PM*
What trouble-free advise, the main thing is that the ss316 material should be 22mm, under one grid

Uncle Fedor in the 22 mm version



Rep: (369)
taking into account conversion losses, the opus could theoretically charge 4 batteries simultaneously with a current of 2A.

there is a pulse converter

I agree with that, I could, but there are problems with cooling, therefore, they limited 1A per channel at 4 and 2A at two batteries.



Rep: (369)
you are mistaken about impulses, charging is powered by 12v 3a, here it charges 4x1A

then the transformer should be in the charger itself, which increases the current strength, but, like, it is not there. And yet, the internal battery voltage is measured in the absence of power supply to it, otherwise how to measure its voltage in the process? That is, in any case, there are pulses during charging. And what prevents these measurements at different times, respectively, so you do not need to simultaneously supply power to each of the batteries.

Post has been editedAlexnight - 30.07.19, 21:41

Full version

Help     rules

Now: 08/27/19, 05:58