Rep: (18)
* al4409 what jambs: blink: You still try custom not on mui, here there are jambs because of xiaomi randomness, and Masik is the top of stability, for me.



Rep: (18)
* simora.lesha Yes, it turned off if it were turned on at such a temperature, and at a lower temperature it was cut down.
Well, it's still a bit too much 80 degrees, didn’t forget the thermal paste, does the radiator fit snugly and evenly, without distortions?

Post has been editedANTIlife - 25.05.19, 20:28



Rep: (18)
* viktor12311 most likely the sensor is lying, touch the radiator, but the temperature is sky-high, so it is definitely lying. Protection in Bios is of course there, but it is redundant, it basically just gives a signal. So, when overheating, it does what it needs, in the extreme case it turns off. Nothing will be .

Post has been editedANTIlife - 25.05.19, 20:17



Rep: (18)
* peligroso , well, I restored the old disk, but I would have taken it at least to Terrabyte, would you recommend taking 12-15 years?



Rep: (18)
If now it makes sense to buy a garbage can plus a second 2TB axis for the file, or is it limited to a terabyte? Are the skills here the data flew from my hard drive to 1 TB, does it now need to be restored somewhere, at the same time doubling the volume makes sense? Or is it anything cardinal in speed from 1 TB, but Silence, power consumption, reliability, and even lose?

Post has been editedANTIlife - 20.05.19, 18:02



Rep: (18)
* peligroso , well, if for example an older terabyte file on one pancake has some recording density, respectively access time, then 2tb on one pancake, theoretically these parameters are better. But in general, in terms of reliability, yes, it’s better to take the second one by 1tb and restore the first one 1tb. But you can, if you still buy, then take 2tb: unsure:
I’m also interested in how far Terrabaitnik technologies have advanced in comparison with my good Hitachi 1 TB 2011, it seems that everyone is happy, noisy, but the mechanics are reliable.



Rep: (18)
* yezd , in the sense of flew away, burned out, are not determined by the system, or just markup, fs nailed down?
I also had a similar case the other day, I disassembled the power supply unit and there are 4 swollen condors (which I had already changed), plus the ceramic conder starts to crumble, well, I replaced it with the next one at par, because it wasn’t, but the transistor could not stand it and flew out. I spat, bought a new one, a chief with cable management, I had wanted this for a long time.

By the way, people, recall the recovery of partitions on the hard drive, which after all this epic accidentally formatted bootice prog when restoring the bootloader, is possible in koumiss.

I found these two sections through AOMEI
Partition Assistant, with a system on drive C and files on D, and if all files are seen on D through the program, then it writes to C empty, although this is exactly that partition with seven. Here, if I restore this program to the partition table and it will not be, what should I format and restore again, will I not lose data like that.
It is very desirable to restore the partitions on the existing hard one, because otherwise you will have to buy a second hard one to drain there, well, there will be a noble mess from the files, plus I’ll lose the seven with everything ready.

Post has been editedANTIlife - 20.05.19, 11:43



Rep: (18)
* yezd , but they make sounds, click there? It’s better to try directly through sat.

Well, if you are afraid of a repetition, it is better to measure the voltage along the lines with a multimeter, the motherboard can trick, and it is necessary to open the power supply, 4 years in a cramped hot case and deshovy capacitors is enough for them to walk, or maybe swollen.

Post has been editedANTIlife - 20.05.19, 11:28



Rep: (18)
* dvaleron Yes, but here the Chinese are mowing down, because after each discovery in the background, the story goes to the very top, closing the tabs yesterday, the day before yesterday and throwing it to the top today.
Where to jump from this ahem ... Worse and worse.

Post has been editedANTIlife - 20.05.19, 09:59



Rep: (18)
I forgot, it was a long time ago ... does a paragorn or akronis have a function for restoring a whole partition with all subfolders?
Somehow I recovered this in a couple of seconds and on the same disk, but now I don’t want to risk, the data and the folder structure and the disk are free, as luck would have it, and I need a terabyte for normal recovery.

Post has been editedANTIlife - 20.05.19, 09:05



Rep: (18)
It’s a good browser of course, about 9 years old on it, but recently it’s started to take off some sort of junk itself, I would like to forget about it, but where else is there such a good page formatting for the screen with remembering the zoom settings. Here it crashed again, with active pages, there was a restart, and when I started, I poked the question of restoring the last session, and what can I do now, can’t I do it like in Mozilla, Chrome, where you can manually load the last session of tabs. Now from the history you can get 15 pages closed by offset with pages that have been read and he shut? Already the ass is burning with this browser, with each new update everything is brighter)))) Here is the back button, what prevented it? : unsure:

Post has been editedANTIlife - 19.05.19, 13:30



Rep: (18)
Karoch, here are the parameters of mikruha. In short, the output current is 700mA! Harmonic distortion up to 112 dB (depending on conditions, is in the table)
Fucking speed up to 1300 V / μs (therefore it can be excited, not always with visible noise, for example at high harmonics, just spoiling the sound quality, therefore, the binding, the wiring of the board is important, which is not always the case with the Chinese), the signal / noise ratio is 128 dB!
Demanding on the purity of power (ripple) suppression of ripple is only 75 dB, normal, but there is better.
The range of the output voltage when powered + - 15V 12.5 - 12.2 V for a load of 25 Ohms (in conjunction with the current gives the output power)

So you are in vain, maybe of course there is no lamp in it, maybe the sound is synthetic to someone, maybe "You don’t like cats? You just don’t know how to cook them"))

Attached images
Attached Image


Post has been editedANTIlife - 15.05.19, 10:38



Rep: (18)
* py13 , this chip is not bad, "civilian" or not rejected, as you like, a variant of the well-known in narrow circles THS 6012, not bad micra with a fucking load capacity, hell 8397, lm6172 have a rest, as far as I remember, laziness is to compare datasheets. She has 32 ohms that 18, that 300 is purple, it’s true that they insure that at the output of most amplifiers there are resistors after the ohms, they are not always good and they are not always needed there, along with the keys and other tinsel spoiling the sound, in short it’s important not the microcircuit, but not least the wiring and proper nutrition is very important.



Rep: (18)
* Bengan777 , I don’t understand why it was necessary to complain to someone, it’s good that the forum directly communicates at this level, and there wasn’t much advertising either. : unsure :. And now everyone who goes to Alik will find out there (who does not know) that there is such a wonderful site)))


The other day, the second zsn pro came to me, blue, the sound seemed a little worse than the first, warming up his mother? I never believed! Ear pads with memory also arrived - they didn’t like it! I took a set of three pairs of different sizes, then the largest are small and do not hold well on the nozzle of the headphones, because there is no plastic core inside, they are all made of this soft material.

Post has been editedANTIlife - 15.05.19, 09:59



Rep: (18)
* Partos_85 , see the blue mix is ​​to blame, according to Doppler)))



Rep: (18)
So, well, here I sew a hawk / Siberia, I choose. In Siberia there are not much less settings, almost the same way, it turned out in Siberia to launch the familiar gesture system from the box (what’s the charm), there it is called differently, and I didn’t want to work until in the settings the reaction time to the gesture did not decrease.
It was possible by combining some settings to drive Siberia into ejection from the settings of Siberia, until the cache was reset, there was no way to go there.

In the hawk, the native camera crashes, maybe because through the recovery the camera2api received, xs cleaning does not help. Third-party cameras work.
I caught the encryption of the partition, forgot to chop it off before flashing it, formatted it through yes, it’s normal, however, it seems that the region has flown, when flashing the language was set to Russian right away, now you should always choose in the settings.

Tell me, is the bist worth attention and how about the settings of the remix resins? I'm not at home right now, there is no unlimited traffic.

Post has been editedANTIlife - 10.05.19, 13:03



Rep: (18)
Well, I tried a few firmwares just now for a dream ...
I simply switched from the old mask on the 7th android, saved all the migrate (drop dead thing), went into the recovery, made a backup of the entire firmware of the mask, updated the firmware, updated the recovery, completely cleared the user memory and began to sew.

The first was PixelExperience goOFFICIAL, even if it started normally, the screen is dark, although you can hear the firmware reaction to the buttons, changed the kernel to genome 4, the same thing, changed the kernel to 3.18 and it worked, it booted. He looked, yes, beautiful, simple, fast, but boring, eats 1.6 memory (approximately)

The next one was the Dot OS, it’s still beautiful, just quickly a little bit above the standard settings, it eats a little, 1.3 (the least of what I tried so far)

The next was Siberia, still fast, beautiful, settings for more than Dotos, it eats memory averagely, 1.5.

And then there was Havok (all delicious last), quickly, beautifully, the settings of the SEA.
By the way, Hawok, the only one where I was able to launch normally familiar gestures (EDGE gestures) out of the box shortened the reaction time for gestures so it became generally good, although it was the same in Siberia and in Dot Os, but even did not want to work as I was used to.
There was little perplexity about the lack of some programs, for example, there is absolutely no browser or player. There are already two radio menus in the menu, but these are trifles.

Even for the sake of the experiment, I put the fact that they threw the last here Vortex os, the firmware is naked, it is very similar to the experience.

Here, I just decided a quick review, for beginners, maybe. I took the latest versions of firmware, the beginning of May and the end of April.
Still it would be necessary to download rezurekshin remich, I remember there were also enough settings.

I chose the firmware according to the functionality, I did not notice the difference in stability (more time is needed, but everything seems decent at first), according to the operative used, the ability to, and preferably the 3.18 kernel, however, what prevents me from installing the correct kernel after.

All firmware except one without built-in gaps.

Post has been editedANTIlife - 10.05.19, 10:11



Rep: (18)
* OFF2ALL Well, all the same, in the second graph it’s closer to 110 dB, and the decibel is a logarithmic measure, a difference of 1 gives linearly 10 times. By the way, somewhere I had them lying around, from the old Sonya, it never happens more original, though the sound is ordinary, as for me, it could become boring, and the nozzles are standard so-so., If you replace them ...

Post has been editedANTIlife - 09.05.19, 20:30



Rep: (18)
* drlexmark In the latest firmware, which one? Stable, developer, version, where was it brought to Omni?



Rep: (18)
* danko843 Yes, about kernels, I read there are kernels with extra compressions turned off and other sound tweaks to make it boom, there is also an interesting module in the magisk, it tightens libraries with good sound specifically for your processor and disables all the rubbish that the manufacturer put on (module for magisk Ainur Sauron, which, depending on the codec and processor, selects patches and libs. He also turns off the compressor and compander, he patches the mixer and reports libs). Does the kernel go as part of the firmware or install it separately?

Post has been editedANTIlife - 06.05.19, 10:10

Full version

Help     rules

Now: 08/15/19, 08:46