Rep: (171)
fox283
If JAF box is, the problem does not occur when the firmware 9300, 9300i, 9500



Rep: (171)
* old technique,
Restore can be via a JTAG programmer. We had seen RIFF box solution I've found to restore



Rep: (171)
* Bs () Dd,
M
You are given a week to transfer the information to the desired sectionsavagemessiahzine.com.
Here it is a violation of the rules


Post has been editedandrei_d1978 - 10.03.20, 09:47



Rep: (171)
Leysann
Try to put in the settings only 2G (GSM only)



Rep: (171)
s_alex9
Only on the programmer razlachivat from the operator. ATF or BEST currently.
PS: People with PG in the discussions here are not looking



Rep: (171)
paraloid
Most likely it is the filter of static.
Take a picture of where the cleaved steklyaha, attach it to the post and under a spoiler photo



Rep: (171)
N8 have encountered a problem (including me) with a proximity sensor proximity switch, while still ASC Nokia could offer only a replacement card



Rep: (171)
ggg111
1 piece Radio Shack think can sell.
The process looks like this, you have to insert the battery into the phone with the connected resistor.
As a result, the screen will read locale fashion.
Then have yusb connecting wire and driver will be placed
The program is reset



Rep: (171)
ggg111
Specifically push resistor is not desirable to contact the battery, to the ends better resistor soldered wiring harness are thin and have push
3rd conclusion connector is Data + should be without it unfortunately will not be a connection.



Rep: (171)
ggg111
And if you enter it in the locale fashion using 10k resistor inserted between the BSI and minus battery and reset the prog mynokiatool, lecturinghere
Photo battery with Internet, the resistor can be soldered thin wires to have climbed to contact the battery.
photo battery
Attached Image


Post has been editedandrei_d1978 - 20.11.19, 15:44



Rep: (171)
* Zekkan
Completely alone can restore the factory rpl was. Here carcass sl3, if simlok broken, it is no lift
You can see the log identification BEST'om? Naturally under the spoiler.



Rep: (171)
* Zekkan
imei not congregate?



Rep: (171)
user_azia
Correctly and legally necessary to write restore imei.
On the facts if no backups, only the factory RPL order before you could to recover. Now when Nokia servaki disabled, you do not.
Change fee. A couple of percents flush with the donor is not profitable right now jibe



Rep: (171)
While living N91, it is sewn on yusb. If the firmware of ridges, the lift only boxing



Rep: (171)
* lo22131,
Because of one device does not make sense to buy a programmer, take in SC



Rep: (171)
* lo22131,
To unlock process programmer is needed.
We are confident that Lochen on att?
RM What is the product?



Rep: (171)
Nobody deleted anything, the latest firmware version in the header.
Other versionshere
I will not fix the previous versions in a hat, as there are a lot of people who sew the first time, and they can easily drop the phone with the wrong slide.



Rep: (171)
Zjdan
For Nokia this platform to choose not particularly out of what. UFS HWK and (or) JAF box



Rep: (171)
* [CYPHERIA] ATOMSK,
In case of a crash, the firmware does not crash, but a partial dump of microcircuits occurs. Percents, memory, KP, etc.



Rep: (171)
deringpavel
Phoenix via USB sews only phones BB5 platform, and 7710 we refer to the DCT-4, which does without programming. Phoenix from 7710 can work, but through the original nokievsky box on the similarity of FPS-8, it was expensive, so the best budget option JAF box, well, or include in SC
As writtenziprak 7710 sewed two cables, the MCU is sewn on the FBUS via JAF box service cable, then the firmware has been going on for USB
Without programming this model does not flash.
photo boxes
Attached Image


Post has been editedandrei_d1978 - 16.11.18, 07:31

Full version

Help     rules

Time is now: 29/04/20, 20:13