Rep: (406)
* melihov07,
It is enough to cut the header from the OF firmware at 0x0 - 0x200 and there will be a firmware for rollback and recovery.
Linux
dd if = original.bin of = tp_recovery.bin skip = 1 bs = 512
Attached Image


Post has been editedvovan26_ - 02.07.19, 18:41



Rep: (406)
* melihov07,
How many times do you need to stick your nose that you need to specify the version of the iron?



Rep: (406)
* genius1010,
Download and install this program. :)
CH341A Programmer (Post vovan26_ # 83071216)



Rep: (406)
* genius1010,
You do everything wrong, spok.nochi. I will explain tomorrow.

Post has been editedvovan26_ - 11.06.19, 22:35



Rep: (406)
* genius1010,
Strange screen.



Rep: (406)
* genius1010,
Lay out the screen as determined by the flash.



Rep: (406)
* genius1010,
Flash programmer determines?
File size corresponds to flash size.
Attached Image


Post has been editedvovan26_ - 11.06.19, 21:17



Rep: (406)
* genius1010,
I need not a firmware, but a dump.
Collect bin (dump) for the programmer (Fast zindani # 77724256)
First, restore the router, and then you will roll out the firmware via tftp.

Post has been editedvovan26_ - 09.06.19, 16:37



Rep: (406)
* genius1010,
Version of the router?



Rep: (406)
* genius1010,
First answer the question.



Rep: (406)
* genius1010,
Cut out the file header, 0x0 - 0x200?



Rep: (406)
genius1010 @ 06/08/19, 18:25*
all permanent reboot

Perezalit OF firmware tftp.

Post has been editedvovan26_ - 08.06.19, 17:01



Rep: (406)
The_Satellite @ 01/06/19 18:20*
Nakatil firmware programmer
Does wi-fi work?



Rep: (406)
* sashik76
Not. CPU1: Qualcomm Atheros QCA9563 (750 MHz)
https://wikidevi.com/wiki/TP-LINK_Archer_C2_v3.x



Rep: (406)
merage @ 11/13/18, 23:51*
The question is, on which system it is desirable to assemble the firmware (not virtual)?
I personally use Debian 9.4 and all the bundle.http://lumpics.ru/conf...an-after-installation/



Rep: (406)
* zindani
You will find Vcc and GND as a tester, Tx and Rx will remain, if you mix them up, then it's okay, change them in places.
Do nothing until you get the programmer, merge the "dead" dump !!! Otherwise, it will not be possible to restore all partitions !!!
Vcc UART and adapter do not connect!
Attached Image


Post has been editedvovan26_ - 14.10.18, 21:58



Rep: (406)
The_Satellite @ 10/07/18 02:46*
The programmer has come. I tried to flash the bootloader combined with the firmware
First of all, you need to merge the native dump !!! Flash the bootloader into the "clean" flash and upload everything else through it.

Full version

Help     rules

Now: 07/19/19, 04:25